Logo

Cart

Click title to display cart contents.
0 Items $0.00

Freightliner S2 Chassis Factory Service & Shop Manual

Catalog: 

Make: 

Model: 

US Dollar: $29.99

Complete workshop & service manual with electrical wiring diagrams for Freightliner S2 Chassis. It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.

This Freightliner S2 Chassis service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

“STI-480, S8 (10_11P).pdf”
Freightliner S2 Chassis Workshop Manual
Models: S2, S2C
STI-480, S8 (10/11P); 1,314 pages

Workshop Manual Contents
Group No. Group Title
00 . . . . . . . . . . . . . . General Information
01 . . . . . . . . . . . . . . . . Engine
09 . . . . . . . . . . . . . . Air Intake
13 . . . . . . . . . Air Compressor
15 . . . . . . . . . . . Alternators and Starters
20 . . . . . . . . . . . Engine Cooling / Radiator
26 . . . . . . . . . . . Transmission
30 . . . . . . . . . Throttle Control
31 . . . . . Frame and Frame Components
32 . . . . . . . . . . . . Suspension
33 . . . . . . . . . . . . . Front Axle
35 . . . . . . . . . . . . . Rear Axle
40 . . . . . . . . Wheels and Tires
41 . . . . . . . . . . . . . . Driveline
42 . . . . . . . . . . . . . . . . Brakes
46 . . . . . . . . . . . . . . . Steering
47 . . . . . . . . . . . . . . . . . Fuel
49 . . . . . . . . . . . . . . . Exhaust
54 . . . . . . . . . . Electrical, Instruments, and Controls
75 . . . . . . . . . . . . . . . . . Body
82 . . . . . Windshield Wipers and Washer
83 . . . . . . . . . Heater and Air Conditioner
88 . . . . . . Hood, Grille, and Cab Fenders
98 . . . . . . . . . . . . . . . . . Paint

— — — — — — — — — — — — — — — — — — — — — — — — — — —

“STI-425-6.pdf”
Freightliner S2 Chassis Maintenance Manual

— — — — — — — — — — — — — — — — — — — — — — — — — — —

“STI-479-6.pdf”
Freightliner S2 Chassis operator’s Manual

EXCERPT:
Alternator, Delco Remy 15.00
Troubleshooting
Many alternators have been replaced that later investigation reveals were working properly. This may be due to incorrectly diagnosing the problem.
IMPORTANT: Before testing, make sure:
· All belts are correctly tightened;
· The wiring and terminals are clean and in good condition;
· All terminal nuts are torqued and properly protected.
Delco Remy has an alternator testing tool called the Intelli-Check Alternator Analyzer. See Fig. 1. This tool (DR 10457848, a single tester, or DR 10457865, a four-pack of testers) is to be used as a quick check of the alternator to see if it is working correctly.
NOTE: If you do not have the Remy Intelli-Check Tester, or if the alternator rated output is above 145 amps, or if a total vehicle charging system analysis is required, see "Alternator/Charging System Testing."
Intelli-Check Alternator Analyzer
The following information includes a pre-test procedure and operating instructions for the Remy Intelli-Check Tester, and is similar to the procedures provided by Remy with the Intelli-Check Tester.
Pre-Test Procedure (Engine Off)
1. Inspect the alternator connections to verify that all terminals are secured and tight. Verify that the sense wire is connected to the sense terminal on vehicles equipped with remote-sense alternators.

Additional 10% off on US$30+ order paid with Credit Card: 10POFF.

To pay in your local currency (EURO, GBP, AUD, CAD, HKD, JPY, etc.), please contact us.