Complete workshop & service manual with electrical wiring diagrams for Doosan DX15, DX18 Crawler Excavator. It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.

This Doosan DX15 / DX18 Crawler Excavator service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

“K1043970AE.pdf”
Doosan DX15 / DX18 Crawler Excavator Shop Manual
K1043970AE; Serial Number 40001 and Up; 513 pages

TABLE OF CONTENTS
Safety
Track Excavator Safety....................... SP001521
Specifications
Specification for DX15/DX18 .............. SP001522
General Maintenance
General Maintenance Procedures................ SP000016
Standard Torques............... SP000813
Upper Structure
Lower Structure and Chassis
Track Assembly .................. SP001523
Engine and Drive Train
Engine................... SP001524
Hydraulics
Center Joint (Swivel)........................... SP001525
Cylinders............... SP001526
Swing Motor................. SP001527
Travel Motor (With Gear Box)............. SP001528
Pilot Control Valve (Work Lever / Joystick)................. SP001529
Main Pump................... SP001530
Main Control Valve ............. SP001531
Solenoid Valve............. SP001532
Hydraulic Schematic (DX15/DX18)............... SP001681
Electrical System
Electrical System................ SP001534
Electrical Schematic (DX15/DX18) ............... SP001535
Attachments
Boom and Arm............. SP001536
Bucket................... SP001550
…

EXCERPT:
ASSEMBLING PROCEDURE
General Attention
1. Clean each part with cleaning solvents before assembling the parts.
2. Keep the parts free from foreign materials. Any foreign materials trapped in the assembled parts may cause seizure, galling, or other troubles.
3. Give special care to protect parts and seals such as O-rings and oil seals from being damaged during assembling or disassembling.
4. The disassembling procedure is in the opposite direction of assembling. Please refer to the cross section drawing and the parts list.
NOTE: Wheel motors include some parts which have been assembled by press fitting. These parts (for example, bearing and pin.) can not be disassembled.
…