Complete workshop & service manual with electrical wiring diagrams for Hyundai Construction Skid Steer Loader HSL650-7, HSL650-7A. It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.

This Hyundai Construction Skid Steer Loader HSL650-7, HSL650-7A service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

EXCERPT:
SKID STEER LOADER HSL650-7
FOREWORD
SECTION 1
GENERAL
Group 1 Safety Hints
Group 2 Specifications
Group 3 Maintenance
SECTION 2
HYDRAULIC SYSTEMUNCTION
Group 1 Hydraulic circuit
Group 2 Hydraulic component testing
Group 3 Self level valve(Option)
Group 4 Auxiliary pump
Group 5 Main pump
Group 6 Travel motor
Group 7 Main control valve
Group 8 Boom and bucket cylinder
SECTION 3
ELECTRICAL SYSTEM
Group 1 Component location
Group 2 Wiring diagram
Group 3 Electrical component specification
Group 4 Connector destination
SECTION 4
POWER TRAIN
Group 1 Power train component
Group 2 Front and rear axle
SECTION 5
CONTROL
Group 1 Hand control
Group 2 Parking brake
Group 3 Attachment holder
SECTION 6
TROUBLE SHOOTING
Group 1 Travel hydraulics
Group 2 Boom and bucket hydraulic
Group 3 Power train
Group 4 Control
Group 5 Electrical system
…
1. ADJUSTMENT OF NEUTRAL
Stop the loader on a level surface and push throttle lever to low.
Raise the canopy to service position.
Refer to operator's manual at page 4-15.
Loosen lock nuts(1) to allow adjust nut(2) to move.
Adjust neutral position by turn adjust nut(2,3) slowly to left and right.
Neutral position means the state in which the equipment should not move and generate noise to minimum without moving reduction gear and hand lever.
To prevent unexpected movement of the loader, keep parking position of seat bar.
Tighten lock nuts(1) after apply loctite.
…