Logo

Cart

Click title to display cart contents.
0 Items $0.00

JCB Articulated Dump Truck 712, 714, 716, 718, 722 Factory Service & Shop Manual

Catalog: 

Make: 

Model: 

Price: $39.99

Complete workshop & service manual with electrical wiring diagrams for JCB Articulated Dump Truck 712, 714, 716, 718, 722. It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.

This JCB Articulated Dump Truck 712, 714, 716, 718, 722 service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

FILELIST:
9803-5000 - JCB Articulated Dump Truck 700- Series (712, 716) Service Manual.pdf
9803-7160 - JCB Articulated Dump Truck 714, 718 Service Manual.pdf
9803-7170 - JCB Articulated Dump Truck 722 Service Manual.pdf
9813-0550 - JCB Articulated Dump Truck 714, 718 Service Manual.pdf

EXCERPT:
Articulated Dump Truck - 722
Section 1 - General Information
Section 2 - Care and Safety
Section 3 - Routine Maintenance
Section B - Body and Framework
Section C - Electrics
Section E - Hydraulics
Section F - Transmission
Section G - Brakes
Section H - Hydraulic Steering
Section K - Engine
Section S - Suspension
...
Service
Manual
ARTICULATED
DUMP TRUCK
714 & 718
General Information
Care & Safety
Routine Maintenance
Optional Equipment
Body & Framework
Electrics
Hydraulics
Transmission
Brakes
Steering
Engine
Suspension...
...
Fitting the Inductive Transmitter
The distance between the contact face of the inductive transmitter and the tip of the teeth on the spur gear must be between 0.6 and 0.8 mm (0.023 and 0.032 inches). If necessary, the clearance can be adjusted by the use of a shim.
To calculate the thickness of the shim required, proceed as follows:
Measure from the tip of the spur gear teeth to the housing face (dimension 1).
Measure from the end face to the shoulder on the inductive transmitter (dimension 2).
For example:
If dimension 1 = 26.20 mm
And the required clearance = 0.70 mm
Then the inductive transmitter can only be allowed to screw in 26.2 - 0.7 = 25.5 mm
If dimension 2 = 26.5 mm
Then shim size = 26.5 - 25.5 = 1 mm
To fit the inductive transmitter, proceed as follows:
1 Assemble the shim (as calculated above) to the inductive transmitter.
2 Fit a new O-ring into the ring groove on the transmission housing.
3 Screw the inductive transmitter in to the housing.
...