Logo

Cart

Click title to display cart contents.
0 Items $0.00

JCB Fastrac 7000 Series (7170, 7200, 7230 P-TRONIC) Factory Service & Shop Manual

Catalog: 

Make: 

Model: 

Price: $29.99

Complete workshop & service manual with electrical wiring diagrams for JCB Fastrac 7000 Series (7170, 7200, 7230 P-TRONIC). It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.

This JCB Fastrac 7000 Series (7170, 7200, 7230 P-TRONIC) service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

9803-8060 - JCB Fastrac 7000 Series (7170, 7200, 7230 P-TRONIC) Service Manual.pdf

EXCERPT:
Service Manual
JCB 7000 Series Fastrac
Section 1 - General Information
Section 2 - Care and Safety
Section 3 - Maintenance
Section A - Optional Equipment
Section B - Body and Framework
Section C - Electrics
Section E - Hydraulics
Section F - Transmission
Section G - Brakes
Section H - Steering
Section S - Suspension
Section T - Engine
...
Dismantling and Assembly
The numerical sequence shown on the illustration is intended as a guide to dismantling K Fig 33. ( T E-25).
Before removing and dismantling the pump, check the flow and pressure for each section of the pump (see Section H, Steering and Section S, Suspension - Technical Data).
If the values are low, renewal of components such as gears, bearings and housings will not effect a permanent cure. If the pump output is satisfactory but there is external leakage, dismantle the pump for re-sealing only.
Note: If the steering flow rate is low, make sure that there is no dirt in the end cover 12 and that the spool 10 moves freely. The size of washer 9 controls the steering flow rate (see Technical Information Bulletin 10/183).
For assembly the sequence should be reversed.
When Dismantling
...