Complete workshop & service manual with electrical wiring diagrams for JCB Skid Steer Loader Range ROBOT 150, ROBOT 160, ROBOT 165, ROBOT 170, ROBOT 180. It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.
This JCB Skid Steer Loader Range 150, 160, 165, 170, 180 service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.
9803-8500 - JCB ROBOT 150, 165 Service Manual.pdf
9803-8520 - JCB ROBOT 160, 170, 180T Service Manual.pdf
9803-9450 - JCB ROBOT 160, 170, 180 Service Manual.pdf
General Information 1
Care & Safety 2
Routine Maintenance 3
Body & Framework B
JCB Robot 160, 170 and 180
Section 1 - General Information
Section 2 - Care and Safety
Section 3 - Maintenance
Section A - Attachments
Section B - Body and Framework
Section C - Electrics
Section D - Controls
Section E - Hydraulics
Section F - Transmission
Section G - Brakes
Section J - Tracks
Section K - Engine
Machine Model and Serial Number
This manual provides information for the following wheeled models in the JCB Skid Steer Loader Range.
– Robot 160 serial number 1602000 to 1604999.
– Robot 160HF serial number 1602000 to 1604999.
– Robot 170 serial number 1602000 to 1604999.
– Robot 170HF serial number 1602000 to 1604999.
– Robot 180 serial number 1602000 to 1604999.
– Robot 180HF serial number 1602000 to 1604999.
This manual also provides information for the following tracked models in the JCB Skid Steer Loader Range.
– Robot 180T serial number 1803000 to 1806999.
– Robot 180T HF serial number 1803000 to 1806999.
Information also covers both wheeled and tracked machines unless otherwise stated.
Track Frame Assembly
1 Raise and support the machine and remove the track (see K Removal ( T J-15)).
2 Disconnect the motor feed and return hoses having marked them for correct reconnection.
3 Sling the track frame as shown and support the weight using a suitable hoist.
4 Remove the bolts from the front mounting.
5 Remove the bolts from the rear mounting. It will be necessary to release the top two bolts gradually whilst easing the frame away from the machine.
Do not pull the frame too far away otherwise the hoses will rip off.
6 Once access has been gained, disconnect the motor drain and brake hoses having marked them for correct reconnection.
7 Manoeuvre the track frame away from the machine.