Logo

Cart

Click title to display cart contents.
0 Items $0.00

Triumph Rocket III 2004-2014 Workshop Repair & Service Manual

Catalog: 

Make: 

Model: 

US Dollar: $12.99

Complete digital official shop manual contains service, maintenance, and troubleshooting information for the 2004-2014 Triumph Rocket III Motorcycle. Diagnostic and repair procedures are covered in great detail to repair, maintain, rebuild, refurbish or restore your bike like a professional mechanic in local service/repair workshop. This cost-effective quality manual is 100% complete and intact as should be without any missing pages. It is the same factory shop manual used by dealers that guaranteed to be fully functional to save your precious time.

This manual for 2004-2014 Triumph Rocket III Motorcycle is divided into different sections. Each section covers a specific component or system and, in addition to the standard service procedures, includes disassembling, inspecting, and assembling instructions. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. It is in the cross-platform PDF document format so that it works like a charm on all kinds of devices. You do not need to be skilled with a computer to use the manual.

EXCERPT:
Table of Contents
Introduction
General Information
Scheduled Maintenance
Cylinder Head
Clutch
Crankshaft
Bevel Box and Drive Shaft
Balancer
Transmission
Lubrication
Engine Removal and Refit
Fuel System/Engine Management
Cooling
Rear Suspension
Front Suspension
Brakes
Wheels/Tyres
Frame and Bodywork
Electrical System

Transmission
Disassembly
Note: All numbers given within brackets in the procedure below, refer directly to the numbered items in the above diagram. Make a note or mark the orientation of all parts prior to removal.
1. Remove the ball bearing (1) and washer (2).
2. Remove first gear (3) and its needle roller bearing (4).
3. Remove the first gear thrust washer (5).
4. Remove fifth gear (6), revealing a circlip (7) that secures fourth and third gears.
5. Remove the circlip (7).
6. Slide off the thrust washer (8) from in front of fourth gear (9), then slide off fourth gear.
7. Slide off third gear (10), the splined third/fourth sgear bush (11) and the thrust washer (12).
8. Remove the circlip (13) from in front of the splined dog ring (14).
9. Slide off the splined dog ring (14).
10. Remove the circlip (15) from in front of second gear (17).
11. Slide off the second gear thrust washer (16), then second gear (17) and its bush (18).
12. Working now from the other end of the shaft, remove the large nut (20) Bellville washer (21) and flat washer (22).
13. Slide off the ball bearing (23), output gear (24) and spacer (25).
Never wear loose clothing, which could become trapped in the press and cause crushing injury to the hand, arms or other parts of the anatomy.
14. Place the shaft (19) in a press with the threaded end of the shaft facing the press ram. Support the centre bearing (26) on press bars.
1. Press
2. Output shaft
3. Centre bearing
15. Press the shaft through the bearing.
Inspection
1. Examine all gears, bearings and bushes and thrust washers for damage, distortion, chipped teeth and wear beyond the service limits. Replace all suspect components and always use new circlips to assemble the shaft.
Assembly
Note: Lubricate each gear, thrust bush with clean engine assembly.
Note: The circlips used on the output shalt have a flat side and an angled side. Illustrations throughout the assembly text indicate which orientation of each circlip is correct.
...

Additional 10% off on US$30+ order paid with Credit Card: 10POFF.

To pay in your local currency (EURO, GBP, AUD, CAD, HKD, JPY, etc.), please contact us.