Logo

Cart

Click title to display cart contents.
0 Items $0.00

Honda CBR250R(R) 1986-1999 Factory Service & Shop Manual

Catalog: 

Make: 

Model: 

US Dollar: $25.00

Complete workshop service manual with electrical wiring diagrams for 1986-1999 Honda CBR250R(R) Motorcycle. It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.

This service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

MAKE: Honda
YEAR: 1986, 1987, 1988, 1989, 1990, 1991, 1992, 1993, 1994, 1995, 1996, 1997, 1998, 1999
MODEL: CBR250FOUR, CBR250R, CBR250RR [CBR250 (FG) and (FG-YA) MC14), CBR250R (H) MC17, CBR250R (J) MC19, CBR250R (K) MC19, CBR250RR (L) MC22, CBR250RR (N) MC22, CBR250RR (R) MC22, CBR250RR (RII) MC22]

"CBR250FOUR_R_RR (G~R) (EN).pdf"
474 pages

"CBR250FOUR_R_RR (G~R) (JP).pdf"
473 pages

"alternative.pdf"
470 pages

EXCERPT:

9. Cylinder, Piston, Crankshaft
Measure the inner diameter of conrod little end
Greater than 13.05mm -> replace
Measure the outside diameter of the piston pin
Smaller than 12.98mm -> replace
Calculate the clearance between the piston and piston pin.
Greater than 0.06mm -> replace
Measure the outside diameter of a piston
Measure at 14mm from the bottom end of the skirt and perpendicular to the piston pin hole.
Smaller than 48.35mm -> replace
Cylinder Inspection
Measure the distortion of the cylinder top surface.
Greater than 0.05mm -> Adjust or replace
Inspect the inner surface of the cylinder.
Measure the inner diameter for X - Y direction at upper, middle, lower part of the cylinder, and record the six numbers.
The maximum number is considered as an inner diameter.
Greater than 48.60mm -> adjust or replace
Calculate the clearance between the cylinder and a piston by measuring the outside diameter of a piston. Take the maximum value.
Greater than 0.10mm -> adjust or replace
Calculate the following parameters and take maximum number:
Circular distortion:
= (X - direction diameter)
= (Y - direction diameter)
Cylindrical distortion:
(Difference in X or Y direction Diameter between three parts).
Both parameters should be < 0.05mm
If greater —> adjust / replace
Inspection / Selection of bearings
Crank pin bearing
Inspect the bearing for scratch,or separation.
Wipe off the oil on the bearing and the crank pin.
Attach the crankshaft.
Avoid oil hole and apply plastic gauge.
Attach the conrod bearing caps to individual crank pins and tighten the bolts.
Tightening Torque: 1.5—1.9kg m
Ensure the crankshaft and conrod do not rotate while measuring.
...

 

Additional 10% off on US$30+ order paid with Credit Card: 10POFF.

To pay in your local currency (EURO, GBP, AUD, CAD, HKD, JPY, etc.), please contact us.