Complete workshop & service manual with electrical wiring diagrams for Saturn LS/LS1/LS2 2000. It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.

This Saturn LS/LS1/LS2 2000 service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

EXCERPT:
Disc & Drum - Saturn "L" Series
DESCRIPTION & OPERATION
Proportioning valves in master cylinder control hydraulic pressure differential between front and rear brakes. Proportioning valves are not serviceable separately from master cylinder. Hydraulic system is split diagonally from front to rear for safety.
BLEEDING BRAKE SYSTEM
NOTE: On models with ABS, see ANTI-LOCK - SATURN article. On all vehicles, use only clean, DOT 3 brake fluid. Keep master cylinder filled with fluid throughout procedure. When bleeding calipers, tap caliper lightly with rubber mallet to help free trapped air.
MANUAL BLEEDING
1. If master cylinder is not suspected of having air in it, go to step 3 . If master cylinder is suspected of having air in it, place cloth under master cylinder to absorb brake fluid. Loosen upper front brakeline at master cylinder. Allow fluid to flow from fitting. Tighten brakeline.
2. Loosen upper front brakeline. Have assistant slowly press brake pedal. While fluid is flowing and pedal is still being held, tighten brakeline. Have assistant slowly release brake pedal. Repeat this step until fluid flow is clear and free of air bubbles, then perform same procedure on upper rear brakeline at master cylinder.
3. Place wrench over bleeder valve of first component to be bled. See BRAKELINE BLEEDING SEQUENCE table. Attach transparent hose to bleeder valve. Submerge other end of hose in container of clean brake fluid.
4. Loosen bleeder valve. Have assistant press and hold brake pedal to floor. Tighten bleeder valve. Have assistant slowly press brake pedal. Repeat procedure until fluid flow is clear and free of air bubbles, then perform same procedure at remaining components in order specified.
5. Fill master cylinder fluid reservoir. Check brake pedal feel. If pedal feels spongy, repeat bleeding procedure.
…