Yamaha BT1100 2002 Factory Service & Shop Manual
Catalog:
Model:
Complete workshop & service manual with electrical wiring diagrams for Yamaha BT1100 2002. It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.
This Yamaha BT1100 2002 service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.
“'02 BT1100 Bulldog.pdf”
Yamaha BT1100 2002 Service Manual: 410 pages
EXCERPT:
ENERATOR AND STARTER CLUTCH
REMOVING THE GENERATOR
1. Remove:
• camshaft sprocket cover
• tappet covers
Refer to "REAR CYLINDER HEAD".
2. Align:
• "T" mark a (with the stationary pointer b)
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Temporarily install the AC magneto cover without the pickup coil and stator coil.
b. Turn the crankshaft clockwise.
c. Align the "T" mark a with the stationary point-
er b on the crankcase cover (left) when the rear piston is at TDC on the compression stroke.
d. Check that the rear piston is at TDC in the compression stroke.
e. The rear piston is at TDC on the compression stroke when there is clearance at both of the rocker arms. If there is no clearance then turn the crankshaft clockwise one full turn.
f. When the "T" mark a is aligned with the stationary pointer the punch mark c on the camshaft sprocket should be aligned with the stationary pointer d on the cylinder head.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
3. Remove:
• generator rotor nut 1 • washer
NOTE:
• While holding the generator rotor 2 with the sheave holder 3, loosen the generator rotor nut. • Do not allow the sheave holder to touch the projection on the generator rotor.
4. Remove:
• generator rotor 1
(with the flywheel puller set 2 and adapter 3)
• woodruff key
…