Complete workshop & service manual with electrical wiring diagrams for Suzuki GSX-R750, GSX-R750W 1993-2008. It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.

This Suzuki GSX-R750, GSX-R750W Motorcycle service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

“GSX-R750 '00-'02.pdf”
MAKE: Suzuki
MODEL: GSX-R750 (GSX-R750Y, GSX-R750K1, GSX-R750K2)
YEAR: 2000 2001 2002
PAGE: 498

“GSX-R750 '96-'99.pdf”
MAKE: Suzuki
MODEL: GSX-R750 (GSX-R750T, GSX-R750V, GSX-R750W, GSX-R750X)
YEAR: 1996 1997 1998 1999
PAGE: 557

“GSX-R750(K4) '04.pdf”
MAKE: Suzuki
MODEL: GSX-R750 (GSX-R750K4)
YEAR: 2004
PAGE: 471

“GSX-R750(K6) '06.pdf”
MAKE: Suzuki
MODEL: GSX-R750 (GSX-R750K6)
YEAR: 2006
PAGE: 552

“GSX-R750(K8) '08.pdf”
MAKE: Suzuki
MODEL: GSX-R750 (GSX-R750K6)
YEAR: 2008
PAGE: 659

“GSX-R750W '93-'95.pdf”
MAKE: Suzuki
YEAR: 1993 1994 1995
MODEL: GSX-R750W (GSX-R750WP, GSX-R750WR, GSX-R750WS)
PAGE: 352

EXCERPT:
1C-1 Engine Electrical Devices:
Engine Electrical Devices Precautions
Precautions for Engine Electrical Device
Refer to “General Precautions in Section 00 (Page 00-1)” and “Precautions for Electrical Circuit Service in Section 00 Engine (Page 00-2)”.
Component Location Engine Electrical Components Location
Refer to “Electrical Components Location in Section 0A (Page 0A-8)”.
Diagnostic Information and Procedures Engine Symptom Diagnosis
Refer to “Engine Symptom Diagnosis in Section 1A (Page 1A-9)”.
…
ECT Sensor Inspection
Refer to “DTC “C15” (P0115-H/L): ECT Sensor Circuit
Malfunction in Section 1A (Page 1A-52)”.
Inspect the ECT sensor in the following procedures:
1) Remove the ECT sensor. Refer to “ECT Sensor Removal and Installation (Page 1C-4)”.
2) Connect the ECT sensor (1) to the circuit tester and place it in the oil (2) contained in a pan, which is placed on a stove.
3) Heat the oil to raise its temperature slowly and read the column thermometer (3) and ohmmeter.
If the ECT sensor ohmic value does not change in the proportion indicated, replace it with a new one.
! CAUTION
• Take special care when handling the ECT sensor. It may cause damage if it gets an excessive sharp impact.
• Do not contact the ECT sensor and column thermometer with a pan.
…