Complete workshop repair service manual with electrical wiring diagrams for Thomas Saf-T-Liner C2 School Bus. It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.

This Thomas Saf-T-Liner C2 School Bus service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

“STI-467, S14.pdf”
Thomas Saf-T-Liner C2 School Bus Workshop/Service Manual
1,606 pages; STI-467, S14 (9/11)
Models: C2, C2 HEV

Workshop Manual Contents
Group No. Group Title
00.... GeneralInformation
01........ Engine
09............ AirIntake
13.... AirCompressor
15.... Alternators and Starters
20.... EngineCooling/Radiator
25........ Clutch
26......... Transmission
30.... ThrottleControl
31............ Frame and Frame Components
32......... Suspension
33.......... FrontAxle
35.......... RearAxle
40...... Wheels and Tires
41........... Driveline
42........ Brakes
46............. Steering
47........ Fuel
49............ Exhaust
54.... Electrical, Instruments, and Controls
72............. Doors
75......... Body
82............ Windshield Wipers and Washer
83.... Heater and Air Conditioner
88........ Hood,Grille,andCabFenders
91........ Seat sand Restraint Systems
98......... Paint
…
— — — — — — — — — — — —

“STI-466-6.pdf”
Thomas Built Buses SAF-T-LINER C2 School Bus Maintenance Manual
Models: C2, C2 G, C2 HEV

Maintenance Manual Contents
00 ............. GeneralInformation
01 ................. Engine
09 ............... AirIntake
13 ........ Air Compressor
15 .......... Alternators and Starters
20 .......... EngineCooling/Radiator
25 ........... Clutch
26 ............ Transmission
31 ............ Frame and Frame Components
32 ................ Suspension
33 ................. Front Axle
35 ................. Rear Axle
40 ......... Wheels and Tires
41 ......... Driveline
42 .......... Brakes
46 ......... Steering
47 ................. Fuel
49 ................ Exhaust
54 ................. Electrical, Instruments, and Controls
72 ........... Doors
83 ........ Heater and Air Conditioner
88........ Hood, Grille, andCabFenders
…

EXCERPT:
Hydraulic Brake System, Bosch
Replacing Hydraulic Line
WARNING
Before working on or around hydraulic brake systems and components, see Safety Precautions 100. Failure to follow those safety precautions may result in personal injury.
Power Brake Booster System
Pressurized ATF reaches the power brake booster through its connection with the power steering gear. From the power brake booster, the ATF returns into the power steering reservoir. See Fig. 1.
1. Park the vehicle on a level surface and apply the parking brake. Shut down the engine. Chock the rear tires.
2. Open the hood.
3. Replace all power steering hoses that are leaking or show signs of cracking, softening, or bulging. If a hose is damaged, replace the entire hose; do not attempt to repair it.
3.1 Remove all hose clamps and tie straps used for routing the hose.
3.2 Using a shop towel over the fittings to catch dripping ATF, disconnect both ends of the hose being replaced.
3.3 Install the new hose.
If replacing the power brake booster supply hose, tighten the supply port connection to 21 ±5 lbf ft (28 ±6 N m), and the outlet connection on the power steering gear 41 lbf ft (56 N m).
If replacing the power brake booster return hose, tighten the hose clamps firmly at the booster return fitting and the power steering reservoir.
3.4 Install the hose clamps and replace any tie straps removed earlier.
…