Complete workshop & service manual with electrical wiring diagrams for Freightliner Recreational Vehicle Chassis. It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.

This Freightliner Recreational Vehicle Chassis service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

“STI-354, S21 (10_10P).pdf”
Freightliner Recreational Vehicle Chassis Workshop Manual
Models: MC, MCL, XC, XCF, XCL, XCM, XCP, XCR, XCS, VCL
STI-354, S21 (10/10P); 1,015 pages

Workshop Manual Contents
Group No. Group Title
00 ...................... General Information
01 ................................ Engine
09 .............................. Air Intake
13 ......................... Air Compressor
15 ................... Alternators and Starters
20 ................... Engine Cooling / Radiator
26 ........................... Transmission
30 ......................... Throttle Control
31 ............. Frame and Frame Components
32 ............................ Suspension
33 ............................. Front Axle
35 ............................. Rear Axle
40 ........................ Wheels and Tires
41 .............................. Driveline
42 ................................ Brakes
46 ............................... Steering
47 ................................. Fuel
49 ............................... Exhaust
54 ............................... Electrical, Instruments, and Controls
83 ................. Heater and Air Conditioner
…

— — — — — — — — — — — — — — — — — — — — — — — — — — —

“STI-425-6.pdf”
Freightliner Recreational Vehicle (RV) Chassis Maintenance Manual
STI-425-6; 107 pages

EXCERPT:
Rear Axle Wheel Hubs and Wheel Bearings 35.01
Axle Components Cleaning and Inspection
Wheel Hub Assembly and
Drive Axle Inspection
1. Inspect the wheel hub flange. A loose wheel assembly will cause the flange to be worn, jagged, or warped. See Fig. 1. Replace the wheel hub if any of these conditions exist.
Inspect the flange surface around the wheel studs. Improperly torqued wheel nuts will cause worn or cracked stud grooves on the hub. See Fig. 2. If wear spots or cracks appear anywhere on the hub, or if the hub is otherwise damaged, replace it with a new one.
2. Remove all the old oil from the spoke wheel or hub cavity. Inspect the inner surface of the wheel or hub for cracks, dents, wear, or other damage.
Replace the wheel or hub if damaged.
3. Remove all the old grease or oil from the surfaces of the wheel bearing cups. Inspect the cups for cracks, wear, spalling, or flaking. See Fig. 3. Replace the cups if damaged in any way; for instructions, see Subject 120.
…