Complete workshop & service manual with electrical wiring diagrams for Doosan DX35Z Crawler Excavator. It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.

This Doosan DX35Z Crawler Excavator service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

“K1025197E.pdf”
Doosan DX35Z Crawler Excavator Shop Manual
K1025197E; Serial Number 5001 and Up; 621 pages

TABLE OF CONTENTS
Safety
Track Excavator Safety ................ SP001061
Specifications
Specification for DX35Z ............... SP001062
General Maintenance
General Maintenance Procedures ........... SP000016
Standard Torques ................... SP000813
Upper Structure
Cabin .............. SP001063
Fuel Tank............. SP001079
Swing Bearing............ SP001064
Lower Structure and Chassis
Track Assembly ......... SP001065
Engine and Drive Train
Drive Coupling (Main Pump) ............. SP001066
Hydraulics
Accumulator.......... SP000028
Center Joint (Swivel) .................... SP001067
Cylinders......... SP001070
Swing Motor ......... SP000987
Travel Motor......... SP000840
Main Pump........... SP000864
Main Control Valve....................... SP001071
Remote Control Valve (Work Lever / Joystick) .............. SP001072
Travel Control Valve..................... SP000839
Pedal Valve.......... SP001073
Hydraulic Schematic (DX35Z)............ SP001074
Electrical System
Electrical System .................... SP001077
Electrical Schematic (DX35Z) ............ SP001078
Attachments
Working Attachments.................... SP001075
Bucket............. SP001076
…

EXCERPT:
Disassembly and Reassembly
Crawler Removal
Crawler removal operation may very dangerous as it should be done with the machine inclined. Never move the machine during removal operation so that the machine may not be tipped over.
When loosening the cartridge valve, do not bring your face near the grease nipple because the inside of the track tension adjusting cylinder is in a high pressure state and allow highly pressurized grease to splash, with the result that the grease nipple may pop out.
Crawler loosening
1. Loosening the cartridge valve of the tension adjusting cylinder drains the grease to loosen the crawlers.
Loosen the cartridge valve slowly.
• The maximum amount of loosening can be obtained if 1/2 turn is made.
…