Click title to display cart contents.
0 Items $0.00

Perkins 700 Series Diesel Engines Factory Service & Shop Manual




Price: $29.99

Complete workshop & service manual with electrical wiring diagrams for Perkins 700 Series (Models UA, UB, UC) 4 Cylinder Naturally Aspirated & Turbocharged Diesel Engines. It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.

This Perkins 700 Series Diesel Engines (704 - 26, 704 - 30 UB, 704 - 30T) service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

User’s Handbook for 700 Series (Models UA, UB, UC) 4 Cylinder Naturally Aspirated & Turbocharged Diesel Engines for Industrial, Agricultural & Fork Lift Truck Applications (TPD1336E8).pdf
Workshop Manual for 700 Series (Models UA, UB, UC) 4 Cylinder Naturally Aspirated & Turbocharged Diesel Engines (TPD1392E3).pdf

"Viton seals"
"Some seals used in engines and in components fitted to engines are made of Viton."
"Viton is used by many manufacturers and is a safe material under normal conditions of operation. If Viton is burned, a product of this burnt material is an acid that is extremely dangerous. Never allow this burnt material to come into contact with the skin or with the eyes."
"If it is necessary to come into contact with components that have been burnt, ensure that the precautions that follow are used:"
"• Ensure that the components have cooled."
"• Use Neoprene gloves and discard the gloves safely after use."
"• Wash the area with calcium hydroxide solution and then with clean water."
"• Disposal of components and gloves that are contaminated must be in accordance with local regulations. If there is contamination of the skin or eyes wash the affected area with a continuous supply of clean water or with calcium hydroxide solution for 15 - 60 minutes. Obtain immediate medical attention."
"Safety cautions when an engine is cleaned"
"Care should be taken, when an engine is cleaned with a high pressure cleaning system."
"• Do not wash an engine while it runs or while it is hot. If cold cleaning fluids are applied to a hot engine, certain components on the engine could be damaged."
"• Leave the engine to cool for at least one hour and disconnect the battery connections before cleaning."
"• Do not wash any part of the fuel injection pump (FIP), cold start device, electrical shut off solenoid (ESOS) or electrical connectors."
"• Ensure that the alternator, starter motor and any other electrical components are shielded and not directly cleaned by the high pressure cleaning system. If these cautions are ignored, the engine or certain components could be damaged, fail to operate and also make the manufacturer’s warranty invalid."