Complete workshop & service manual with electrical wiring diagrams for Daihatsu Charade 1987-1993. It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.

This Daihatsu Charade 1987-1993 service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

FORMAT: PDF
LANGUAGE: English
SIZE/PAGE: 989 Pages
OS: Windows/Mac OS X/Linux/Android/iOS

'87-'93 Charade (G100, G102 Series)
Daihatsu Type CB Engine (CB-23, CB-61 & CB-80)

EXCERPTS:
FRONT AXLE & SUSPENSION
1. Disc brake cover replacement
(1) Separate the disc brake cover from the knuckle, using a common screwdriver or the like.
NOTE:
Do not remove the disc brake cover unless its replacement is required.
(2) Press the disc brake cover until it comes into close contact with the knuckle, using the following SSTs. SST: 09506-87302-000 09718-87701-000
INSTALLATION
1. Front axle bearing installation
(1) Press the bearing into position, using the following
SSTs. SST: 09506-87302-000 09550-10012-000 (09554-10010-000, part of the proceeding tool)
(2) Install a new snap ring, using snap ring pliers.
(3) Press the front axle hub into position, using the following SST. SST: 09550-10012-000 (09554-10010-000, part of the proceeding tool)
2. Steering knuckle installation
(1) Insert the steering knuckle into the drive shaft.
NOTE:
• Be careful not to allow the drive shaft to come into contact with the oil seal at the knuckle side.
• Pay utmost attention not to damage the ball joint dust
cover.
(2) Mount the steering knuckle on the lower ball joint.
(3) Mount the steering knuckle on the shock absorber lower bracket. Tighten the bolts and nuts.
Tightening Torque: 9.0 - 13.0 kg-m (65 - 94 ft-lb)
NOTE:
With the knuckle pushed against the lower side, tighten the bolts and nuts.
(4) Install the lower ball joint. Tighten the bolt and nut. Tightening Torque: 8.0 - 10.5 kg-m (58 - 76 ft-lb)
(5) Install the washer. Install the nut temporarily.
NOTE: Be sure to install the washer in the correct direction.

3. Install the disc rotor.
NOTE:
Care must be exercised to ensure that no foreign matter lodge between the hub and the disc rotor.
4. Disc brake caliper installation
(1) Install the pad guide plate to the steering knuckle.
(2) Tighten the attaching bolts of the disc brake caliper. Tightening Torque: 3.2 - 4.2 kg-m (23 - 30 ft-lb).