Complete workshop & service manual with electrical wiring diagrams for Cagiva Canyon, Gran Canyon Motorcycle. It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.

This Cagiva Canyon, Gran Canyon Motorbike service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

8000 82598 - Canyon - 600 Workshop Manual.pdf
8000 88273 - Canyon Workshop Manual.pdf
8000 88560 - Gran Canyon Workshop Manual.pdf

EXCERPT:
Rear wheel removal.
Place under the engine a support to lift the wheel from the ground, then proceed as follows:
- remove the chain cover acting on the four screws securing it is fork
- remove the nut of the wheel axle (1 I then extract the axle;
- push forward the wheel to allow the chain and crown removal;
- extract the wheel from the fork paying attention to the caliper holder plate which, in this way, will result free from its fastening; keep the spacers located on both wheel sides and, if necessary, extract the flange with flexible coupling and ring gear from the rear hub.
As for the operations for flange and wheel bearings replacement, and for the checking of the pin and wheel rim, perform the same operations used for the front wheel removal. During the re-assembly it is necessary to check the chain tension and the index alignment on both sides of the fork.
…