Complete digital official shop manual contains service, maintenance, and troubleshooting information for the 2002-2015 BMW 7-Series 760i, 760Li. Diagnostic and repair procedures are covered in great detail to repair, maintain, rebuild, refurbish or restore your vehicle like a professional mechanic in local service/repair workshop. This cost-effective quality manual is 100% complete and intact as should be without any missing pages. It is the same factory shop manual used by dealers that guaranteed to be fully functional to save your precious time.

This manual for 2002-2015 BMW 7-Series 760i, 760Li is divided into different sections. Each section covers a specific component or system and, in addition to the standard service procedures, includes disassembling, inspecting, and assembling instructions. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. It is in the cross-platform PDF document format so that it works like a charm on all kinds of devices. You do not need to be skilled with a computer to use the manual.

EXCERPT:
2013 BMW 760Li
ACCESSORIES AND BODY, CAB Body
3.0 Adhesive application
Processing temperature of glue cartridge 18 °C - 30 °C.
Object temperature, vehicle and new parts, min. 15°C.
After applying the adhesive, check whether an adhesive component has emerged at the back of the glue cartridge. If yes, break off the bonding procedure. Clean new part. Use new glue cartridge. Contact
national hotline.
Join components and secure in position.
Remove excess adhesive. Do not use solvent cleaning agents.
4.0 Hardening times
Refer to NOTES REGARDING ADHESIVE K1
5.0 Subsequent treatment of bonding surfaces
Protect the repair area with cavity sealant.
41 00... CARRYING OVER HOLE PATTERN
When replacing a body component, it is necessary to carry over the hole pattern from the existing body to the new component.
The following pictures are a schematic representation of carrying over the hole pattern on the example of the front wheel arch.
Necessary preliminary tasks:
Adjust new part to fit with straightening attachment.
Insert paper stencil (1) between new component (2) and engine carrier and secure with adhesive tape (3).
Carry over contour (4) of new component to stencil.