Logo

Cart

Click title to display cart contents.
0 Items $0.00

Lincoln MKT 2010 Factory Service & Shop Manual

Catalog: 

Make: 

Model: 

US Dollar: $19.99

Complete workshop & service manual with electrical wiring diagrams for Lincoln MKT 2010. It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.

This Lincoln MKT 2010 service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

· J5A - Lincoln MKT, All-Wheel Drive (AWD)
· J5F - Lincoln MKT, Front Wheel Drive (FWD)
· R - 3.7L, Durataec, 4 valve, V6
· T - 3.5L, Gasoline Turbocharged Direct Injection (GTDI), V6

EXCERPT:
2010 MKT
Workshop Manual
Quick Links
Introduction
Master DTC Chart
Specifications
Metrics
Torque Wrench Adapter Formulas
Acronyms
Alphabetical Index
Table of Contents
1: General Information
00: Service Information
2: Chassis
04: Suspension
05: Driveline
06: Brake System
11: Steering System
3: Powertrain
03: Engine
07: Automatic Transmission
08: Manual Transmission, Clutch and Transfer Case
09: Exhaust System
10: Fuel System
4: Electrical
12: Climate Control System
13: Instrumentation and Warning Systems
14: Battery and Charging System
15: Audio Systems
17: Lighting
18: Electrical Distribution
19: Electronic Feature Group
5: Body and Paint
01: Body
02: Frame and Mounting

Front Door Latch
Removal and Installation
NOTE: The door glass must be completely raised.
1. Remove the front door trim panel. For additional information, refer to Section 501-05 .
2. For the driver door, remove the door lock cylinder. For additional information, refer to Door Lock Cylinder in this section.
3. For the passenger door, remove the exterior door handle. For additional information, refer to Exterior Door Handle in this section.
4. Position the water shield aside.
5. Disconnect the front door latch actuator electrical connector.
6. Remove the door lock rod extension from the door lock rod.
7. Push the door lock rod and grommet through the door panel.
8. Push the interior door handle cable and grommet through the door panel, and pull them back out through the door panel access hole.
9. Remove the door latch carrier screw.
10. Remove the 2 window glass rear track nuts.
· To install, tighten to 11 Nm (97 lb-in).
11. NOTICE: To prevent the front door glass from breaking, do not use excessive force when pushing on the window glass track.
Push the lower window glass track stud through the door panel towards the front of the vehicle.
12. Loosen the exterior door handle reinforcement bolt.

Additional 10% off on US$30+ order paid with Credit Card: 10POFF.

To pay in your local currency (EURO, GBP, AUD, CAD, HKD, JPY, etc.), please contact us.