Complete digital official shop manual contains service, maintenance, and troubleshooting information for the 2008-2016 Buick Enclave (Convenience/Leather/Premium). Diagnostic and repair procedures are covered in great detail to repair, maintain, rebuild, refurbish or restore your vehicle like a professional mechanic in local service/repair workshop. This cost-effective quality manual is 100% complete and intact as should be without any missing pages. It is the same factory shop manual used by dealers that guaranteed to be fully functional to save your precious time.

This manual for 2008-2016 Buick Enclave (Convenience/Leather/Premium) is divided into different sections. Each section covers a specific component or system and, in addition to the standard service procedures, includes disassembling, inspecting, and assembling instructions. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. It is in the cross-platform PDF document format so that it works like a charm on all kinds of devices. You do not need to be skilled with a computer to use the manual.

EXCERPT:
2013 RESTRAINTS Seat Belts - Acadia, Enclave And Traverse
Circuit/System Description
The inflatable restraint sensing and diagnostic module (SDM) sends the status of the driver seat belt switch via serial data to the instrument panel cluster (IPC). After receiving the message, the IPC controls the illumination of the driver seat belt indicator.
Reference Information
Schematic Reference
Seat Belt Schematics
Connector End View Reference
Component Connector End Views
Description and Operation
Seat Belt System Description and Operation
Electrical Information Reference
Circuit Testing
Testing for Intermittent Conditions and Poor Connections
Connector Repairs
Wiring Repairs
Scan Tool Reference
Control Module References for scan tool information
Circuit/System Verification
1. Ignition ON, command the instrument panel cluster lamp test ON and OFF with a scan tool. The driver seat belt indicator should turn ON and OFF when changing between the commanded states.
If the indicator does not illuminate, replace the IPC.
2. Observe the scan tool Driver Seat Belt Switch parameter while connecting and disconnecting the seat belt. The parameter should display Buckled and Unbuckled when changing between seat belt states.
Circuit/System Testing
...