Complete workshop & service manual with electrical wiring diagrams for Case JX60, JX70, JX80, JX90, JX95 Model Tractors. It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.

This Case JX60, JX70, JX80, JX90, JX95 Model Tractors service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

Case JX60, JX70, JX80, JX90, JX95 Model Tractors Service Manual.pdf

EXCERPT:
SECTIONS
GENERAL . . . 00
ENGINE . . . . 10
CLUTCH . . . . 18
GEARBOX . . . 21
TRANSMISSION OF MOTION . . . .23
FRONT MECHANICAL TRANSMISSION . . . . 25
REAR MECHANICAL TRANSMISSION . . . 27
POWER TAKE-OFF . . 31
BRAKES . . . . 33
HYDRAULIC SYSTEMS . . 35
STEERING . . . 41
AXLE AND WHEELS . . . . 44
AUXILIARY EQUIPMENT . . . . 50
ELECTRICAL SYSTEM . . .55
CAB . . 90
...
28 SECTION 25 -- MECHANICAL FRONT AXLE -- CHAPTER 1
6- 62720 -- 09 -- 2006
Second class axle mod. JX80, JX90 and JX95
Proceed as follows:
-- Progressively tighten the ring nut, using the torque wrench and wrench 380000269 (1) to obtain a torque value of 392 Nm (289.12432 ft lb); at the same time, rotate the wheel hub to ensure that the bearings are correctly seated.
-- Measure the rolling resistance (Rt) of the wheel hub using the relative torque wrench, or a torque meter and cord positioned on the base of the wheel disk flange.
-- Loosen the ring nut by half a turn and measure the rolling resistance (R) as described previously. The difference between the two measurements is the rolling torque value of the wheel hub bearings (Rc):
-- Rc = Rt -- R = 5.9 ÷ 14.7 Nm (4.3516 ÷ 10.8416 ft lb) or if measured with a torque meter.
Rc = Rt -- R = 7.5 ÷ 18.75 kg (41.3554 lb).
-- If the measurement is less than 5.9 Nm (4.3516 ft lb) or with the torque meter on 4.8 kg (10.5870 lb) it is necessary to replace the affected parts and repeat the check.
-- Progressively tighten the ring nut, using the torque wrench and wrench 380000269 (1) to obtain a torque value of 392 Nm (289.12432 ft lb); at the same time, rotate the wheel hub to ensure that the bearings are correctly seated.
-- Carefully secure the ring nut
...