Complete workshop & service manual with electrical wiring diagrams for JCB 1CX, 208S Backhoe Loader. It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.

This JCB 1CX, 208S Backhoe Loader service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

9803-8550 - JCB 1CX, 208S Backhoe Loader Service Manual.pdf
9803-9960 - JCB 1CX Backhoe Loader (Series 1 & Series 2) Service Manual.pdf

EXCERPT:
General Information 1
Care & Safety 2
Routine Maintenance 3
Attachments A
Body & Framework B
Electrics C
Controls D
Hydraulics E
Transmission F
Brakes G
Engine K
...
Service Manual - 1CX
Section 1 - General Information
Section 2 - Care and Safety
Section 3 - Maintenance
Section A - Attachments
Section B - Body and Framework
Section C - Electrics
Section E - Hydraulics
Section F - Transmission
Section G - Brakes
Section J - Tracks
Section K - Engine
...
Pumps
Removal and Replacement
Fig 1.
Note: The illustration shows an early pump but although later pumps are visually different the same procedure applies.
Removal
Disconnect the battery. Remove the front floor plates. See Section 3. Drain the hydraulic tank. Disconnect the microswitch at the base of the seat. Remove the two front and the left hand rear bolts securing the seat. Slacken but do not remove the right hand rear bolt. The seat can now be rotated towards the rear of the machine. Unclip the wiring loom and battery lead from the front seat mounting rail. Remove the seat mounting rail.
...