Complete workshop & service manual with electrical wiring diagrams for JCB 323HST, 327HST Groundcare Tractors. It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.

This JCB 323HST, 327HST Groundcare Tractors service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

9803-9470 - JCB 323HST, 327HST Groundcare Tractors Service Manual.pdf

EXCERPT:
Section 1 - General Information
Section 2 - Care and Safety
Section 3 - Maintenance
Section A - Attachments
Section C - Electrics
Section E - Hydraulics
Section F - Gearboxes
Section G - Brakes
Section H - Steering
Section K - Engine
...
Diff Case and Bevel Pinion
1 Apply grease to each friction surface.
2 The bevel pinion and the ring gear are paired after mesh adjustment is performed at the factory. When reassembling the pair, make sure to pair parts with a same reference number.
3 When installing the taper roller bearings on the bevel pinion, make sure you install a new lock nut and secure it as shown K Fig 73. ( T F-69).
4 Install the snap ring and install the bevel pinion together with the taper roller bearings K Fig 75. ( T F-71).
5 Install the bearings in the axle housing and assemble the ring gear in the axle housing.
Fig 75.
6 Install a new parallel pin 4.
7 When either the bevel pinion, ring gear, taper roller bearing, collar etc. have been replaced, check the bevel pinion assembly (through the drain plug hole) for the specified thrust play of 0.1 - 0.2 mm (0.004 -0.008 in) in the front axle housing.
...