Complete workshop & service manual with electrical wiring diagrams for JCB Wheeled Loading Shovel 411, 416. It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.
This JCB Wheeled Loading Shovel 411, 416 service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.
9803-4150 - JCB Wheeled Loading Shovel 411, 416 Service Manual.pdf
Wheeled Loading Shovel - 411, 416
Section 1 - General Information
Section 2 - Care and Safety
Section 3 - Routine Maintenance
Section A - Attachments
Section B - Body and Framework
Section C - Electrics
Section E - Hydraulics
Section F - Transmission
Section G - Brakes
Section H - Hydraulic Steering
Section K - Engine
To pressure test and re-set the Auxiliary Relief Valve (ARV), service kit 892/00309 must be used.
The service kit comprises; a test block 62-1, a setting body 62-2 with adjusting pin 62-3, a special spanner 62-4 and an anti-cavitation lock out bung 62-5. ARV cartridge removal tool 892/00335 comprises: an extractor cap 62-11 and a 'C' washer 62-12.
1 Remove the complete ARV assembly from the excavator valve block. If the ARV sub-assembly 63-7 remains in the valve block, proceed as follows:
a Fit extractor cap 63-11 over the ARV subassembly 63-7, into the excavator valve block 63-E.
b Fit 'C' washer 63-12 on top of the extractor cap, but under the anti-cavitation spring seat as shown.
c Unscrew the extractor cap, - the ARV subassembly will withdraw with the extractor cap.