Complete workshop & service manual with electrical wiring diagrams for JCB Excavators 8056. It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.
This JCB Excavators 8056 service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.
9803-9296 - JCB Excavators 8056 Service Manaual.pdf
Section 1 - General Information
Section 2 - Care and Safety
Section 3 - Maintenance
Section A - Attachments
Section B - Body and Framework
Section C - Electrics
Section D - Controls
Section E - Hydraulics
Section F - Gearboxes
Section J - Track and Running Gear
Section K - Engine
Removal and Replacement
1 Raise the engine cover.
2 Disconnect the battery. Disconnect the earth lead first.
3 Loosen the alternator mounting bolt A located underneath the alternator and B and on the adjusting bracket. Remove the fan belt C from the alternator drive pulley.
4 Disconnect the electrical connections from the alternator.
5 Support the alternator and remove the mounting bolts.
6 Remove the alternator.
1 Put the alternator in position and install the mounting bolts, Do not tighten the bolts.
2 Put the fan belt on to the pulley.
3 Depress the fan belt C at the centre between the alternator pulley and the crankshaft pulley with a finger force of 49Nm, (11lbf - 5kgf) approx. The belt deflection should be 10 mm (0.4in) approx.
4 Connect the electrical connections.
5 Reconnect the battery.
Important: Connect the earth lead last.
B 6 Close the engine cover.