Complete workshop repair & service manual with electrical wiring diagrams for  Massey-Ferguson MF 4600 Series Tractors (4608/4609/4610). It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.

This Massey-Ferguson MF 4600 Series Tractors (4608/4609/4610) service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

FILELIST:
4283492M3 - AGCO/Massey-Ferguson MF 4600 Series Tractors (4608/4609/4610) Service Manual.pdf
828 pages; High Quality PDF

EXCERPT:
2 CRANKSHAFT
2.1 Removing Crankshaft
1. Remove the oil sump and the suction pipe.
2. Disconnect the balancing unit lubricating oil pipe from the cylinder block and unscrew the balancing unit fixing bolts. Remove the balancing unit and the lubricating oil pipe (only 44-engines).
3. Remove the flywheel and the crankshaft oil seal with the housing.
4. Remove the speed sensors and the timing gear cover. (see instruction 5.1. ).
5. Remove the connecting rod bearing caps and push the connecting rods out of the way of the crankshaft.
6. Remove the main bearing caps and lift out the crankshaft.
2.2 Checking Crankshaft
1. Clean the crankshaft. Do not forget the oil ways.
2. Measure the journal wear in several points. Out-of-round, taper or other wear must not exceed 0.03 mm.
3. Refit the bearing caps with new bearing shells and tighten them to the correct torque. Measure the I.D. with a dial gauge which has been zeroed to the dimensions given in point 2. With this method the indicator shows the actual bearing clearance. Measure at several points in case the worn bearing housing is not round.
4. Maximum allowed bearing clearance is 0.18 mm for main bearings or 0.14 mm for connecting rod big-end bearings with new bearing shells.
2.3 Changing Crankshaft Gear
1. Break the crankshaft gear using e.g. a grinder. Grind the gear sufficiently.
Hit the gear apart with a chisel. Do not damage the crankshaft!
2. Clean the seat on the crankshaft, for example, with a wire brush.
3. Install key pins to crankshaft (if removed). Use one drop of Loctite 603 or equivalent to ensure adhesion.
4. Heat the new gear to 190'Ct.1 O'C .
5. Tap the gear onto the shaft with drift 9103 94700. Ensure that the aligning marks on the gear are visible. No clearance is allowed between gear surface and crankshaft surface (arrowed).
6. Let the gear cool without using any coolant.
...