Complete workshop & service manual with electrical wiring diagrams for Caterpillar 3508C/3512C/3516C Generator Set / Industrial / Machine / Marine / Petroleum Engines. It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.
This Caterpillar 3508C/3512C/3516C Generator Set / Industrial / Machine / Marine / Petroleum Engines service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.
SEBP4364 - Parts Manual (3512C Engine).pdf
KENR5402 - Specifications (3500C Marine Engines)
KENR5403 - Systems Operation (3500 Marine Engines)
KENR5403 - Testing & Adjusting (3500 Marine Engines)
KENR5405 - Troubleshooting (3500C Marine Auxiliary Engines)
KENR6055 - Disassembly & Assembly (3508C, 3512C, 3516C Marine Engines)
UENR4397 - Testing & Adjusting (3516C High Displacement Industrial Engine)
UENR0576 - Specifications (3516C Petroleum Engines)
UENR0577 - Systems Operation (3516C HD Petroleum Well Service Engines)
UENR0577 - Testing & Adjusting (3516C HD Petroleum Well Service Engines)
UENR0578 - Troubleshooting (3516C HD Petroleum Well Service Engines)
UENR2650 - Schematic (3516C Well Fracturing Engine Electrical System)
UENR3273 - Disassembly & Assembly (3516C Petroleum Engines)
UENR4397 - Systems Operation (3516C High Displacement Industrial Engine)
KENR5415 - Specifications (3512C & 3516C Industrial Engines)
6. Use Tooling (E) and a suitable press to install rotating seal group (6). Rotating seal group (6) is to be installed with installation clips (X) in place until rotating seal group (6) is fully seated. Remove installation clips (X).
Note: Do not use hammer to install seal groups as damage to the ceramic faces on the seal groups will occur.
7. Lubricate the shaft assembly with a light coat of engine oil. Use a suitable press to install impeller (5) into pump housing (10) and onto the shaft assembly. Install impeller (5) to a depth of 0.0 ± 0.15 mm (0.00000 ± 0.00591 inch) from the end of the shaft assembly to the outer face of the impeller.