Complete technical Repair Manual for John Deere 9560 and 9660 Combines. It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.

John Deere 9560 and 9660 Combines Technical manual (Repair) (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

TM2161 - 9560 and 9660 Combines Technical manual (Repair).pdf
5,261 pages, bookmarked, Searchable, Printable, high quality PDF

CONTENTS
Foreword
10 - General Information
20 - Engine
30 - Fuel and Air System
40 - Electrical System
50 - Power Train
60 - Power Steering and Brakes
70 - Hydraulic System
80 - Separator Shell
90 - Operator Station
110 - Feeder House
120 - Separator
130 - Grain Tank and Unloading System
140 - Engine Gear Case and Control Valve
199- Dealer Fabricated Tools

SAMPLE TEXT:
Adjust Displacement Control Valve Neutral
H70564-UN: Control Valve
H54264-UN: Displacement Control Valve
LEGEND:
A - Plug (2 used)
B - Set Screw
C - Adjusting Screw
D - Control Lever
E - Return Spring
F - Spool
NOTE:
The control valve can be adjusted for neutral position as follows without removing it from the hydrostatic unit.
1. Check linkage neutral adjustment before checking control valve neutral.
2. Remove two plugs (A) on the side of valve. (Same side as control lever.)
3. Loosen set screw (B).
4. Use pliers to turn out adjusting screw (C) two full turns.
5. Look into open ports at spool valve (F) and move control lever (D) slightly in both directions.
6. Do not move lever enough to compress return spring (E). Turn adjusting screw (C) in slowly while moving lever (D) in both directions.
7. When end play of spool is eliminated, the adjustment is made. End play should be observed while looking through holes at spool (F). Movement in control lever (D), after end play is eliminated, is caused by wear in the linkage.
8. Tighten screw (B) and install plugs (A).
...

John Deere 9560 and 9660 Combines Technical manual (Repair) (TM2161)