Complete digital official shop manual contains service, maintenance, and troubleshooting information for the GMC Acadia 2007-2016. Diagnostic and repair procedures are covered in great detail to repair, maintain, rebuild, refurbish or restore your vehicle like a professional mechanic in local service/repair workshop. This cost-effective quality manual is 100% complete and intact as should be without any missing pages. It is the same factory shop manual used by dealers that guaranteed to be fully functional to save your precious time.

This manual for GMC Acadia 2007-2016 is divided into different sections. Each section covers a specific component or system and, in addition to the standard service procedures, includes disassembling, inspecting, and assembling instructions. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. It is in the cross-platform PDF document format so that it works like a charm on all kinds of devices. You do not need to be skilled with a computer to use the manual.

EXCERPT:
2014 TRANSMISSION Automatic Transmission - 6T75 (M7V M7X) - Repair Instructions - On Vehicle - Acadia, Enclave And Traverse
TRANSMISSION CONTROL LEVER KNOB REPLACEMENT (ACADIA)
Removal Procedure
1. Apply the parking brake.
2. Remove the floor console left extension panel. Refer to Front Floor Console Extension Panel Replacement - Left Side (Acadia) .
3. Disconnect the transmission tap up/tap down switch electrical connector (1).
Fig. 2: View Of Transmission Tap Up/Tap Down Switch Electrical Connector
4. Rotate the key to the RUN position, however do NOT start the vehicle.
5. Move the transmission shift control lever rearward.
6. For vehicles with push-to-release style solenoid, carefully insert a small flat-bladed tool between the trim ring (2) and the shift knob. Apply careful downward pressure to the shift knob trim ring to separate the trim ring from the shift knob. The trim ring will drop down approximately 13.0 mm (0.5 in) exposing the shift knob retaining screw.
Fig. 3: Identifying Shift Control Knob Screw And Trim Ring
7. For vehicles with pull-to-release style solenoid, carefully apply downward pressure to the shift knob trim ring to separate the trim ring from the shift knob. The trim ring will drop down approximately 13.0 mm (0.5 in) exposing the shift knob retaining screw.
8. Remove the shift control knob screw (1) from the shift control knob.
9. Remove the shift control knob (1) from the shift control lever.
Fig. 4: View Of Shift Control Knob
NOTE: Carefully guide the transmission tap up/tap down switch electrical harness and connector past the shift control indicator while removing the shift control knob.
Installation Procedure
1. For vehicles with push-to-release style solenoid, apply lubricant GM P/N 88861426 (Canadian P/N 88861442) to the tip of the shift control lever. Otherwise, proceed to step 2.
2. Install the shift control knob (1) to the shift control lever.
Fig. 5: View Of Shift Control Knob
3. Install the control knob screw (1) and tighten to 4 N.m (35 lb in).
...