Complete digital official shop manual contains service, maintenance, and troubleshooting information for the Suzuki Equator 2008-2012. Diagnostic and repair procedures are covered in great detail to repair, maintain, rebuild, refurbish or restore your vehicle like a professional mechanic in local service/repair workshop. This cost-effective quality manual is 100% complete and intact as should be without any missing pages. It is the same factory shop manual used by dealers that guaranteed to be fully functional to save your precious time.

This manual for Suzuki Equator 2008-2012 is divided into different sections. Each section covers a specific component or system and, in addition to the standard service procedures, includes disassembling, inspecting, and assembling instructions. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. It is in the cross-platform PDF document format so that it works like a charm on all kinds of devices. You do not need to be skilled with a computer to use the manual.

EXCERPT:
2012 ENGINE Engine Mechanical - VQ40DE - Equator
REPAIR INSTRUCTIONS
DRIVE BELTS: EXPLODED VIEW
Fig. 6: Exploded View Of Drive Belt (VQ40DE)
CHECKING DRIVE BELTS
1. Remove air duct and resonator assembly when inspecting drive belt. Refer to AIR CLEANER AND AIR DUCT: REMOVAL AND INSTALLATION
2. Make sure that the auto tensioner indicator is within the allowable working range (A) as shown.
Fig. 7: Identifying Auto Tensioner Indicator Allowable Working Range
3. Visually check entire belt for wear, damage or cracks.
4. If the indicator is out of allowable working range or drive belt is damaged, replace the drive belt. Refer to DRIVE BELTS: REMOVAL AND INSTALLATION
DRIVE BELTS: ADJUSTMENT
There is no manual drive belt tension adjustment. The drive belt tension is automatically adjusted by the drive belt auto tensioner.
DRIVE BELTS: REMOVAL AND INSTALLATION
REMOVAL
1. Remove air duct and resonator assembly. Refer to [AIR CLEANER AND AIR DUCT: REMOVAL AND INSTALLATION].
2. Rotate the drive belt auto tensioner in the direction of arrow (loosening direction of tensioner) as shown, using suitable tool.
Fig. 8: Rotating Drive Belt Auto Tensioner
WARNING: Avoid placing hand in a location where pinching may occur if the tool accidentally comes off.
3. Remove the drive belt.
INSTALLATION
Installation is in the reverse order of removal.
DRIVE BELT AUTO TENSIONER AND IDLER PULLEY: REMOVAL AND INSTALLATION
Fig. 9: Identifying Drive Belt Auto Tensioner And Idler Pulley
REMOVAL
1. Remove air duct and resonator assembly. Refer to [AIR CLEANER AND AIR DUCT: REMOVAL AND INSTALLATION].
2. Remove drive belt. Refer to [DRIVE BELTS: REMOVAL AND INSTALLATION].
3. Remove auto tensioner and idler pulley using power tool.
INSTALLATION
Installation is in the reverse order of removal.
AIR CLEANER FILTER: EXPLODED VIEW
Fig. 10: Exploded View Of Air Cleaner (VQ40DE)
AIR CLEANER FILTER: REMOVAL AND INSTALLATION
REMOVAL
1. Disconnect air duct and resonator from the air cleaner case (upper).
2. Disconnect MAF/IAT sensor.
3. Unhook clips, and lift air cleaner case (upper).
4. Remove air cleaner filter.
INSTALLATION
Installation is in the reverse order of removal.
CAMSHAFT VALVE CLEARANCE
INSPECTION
...