Complete digital official shop manual contains service, maintenance, and troubleshooting information for the Buick Allure 2005-2010. Diagnostic and repair procedures are covered in great detail to repair, maintain, rebuild, refurbish or restore your vehicle like a professional mechanic in local service/repair workshop. This cost-effective quality manual is 100% complete and intact as should be without any missing pages. It is the same factory shop manual used by dealers that guaranteed to be fully functional to save your precious time.

This manual for Buick Allure 2005-2010 is divided into different sections. Each section covers a specific component or system and, in addition to the standard service procedures, includes disassembling, inspecting, and assembling instructions. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. It is in the cross-platform PDF document format so that it works like a charm on all kinds of devices. You do not need to be skilled with a computer to use the manual.

EXCERPT:
2009 ENGINE Engine Mechanical - 5.3L - Allure (Canadian) & LaCrosse
REPAIR INSTRUCTIONS - OFF VEHICLE
DRAINING FLUIDS AND OIL FILTER REMOVAL
Fig. 318: View Of Oil Pan Drain Plug & O-Ring
1. Remove the oil pan drain plug (430) and O-ring (429).
Fig. 319: View Of Engine Oil Filter
2. Remove the engine oil filter (437).
Fig. 320: Right Side Rear Engine Block Coolant Drain Hole Plug And Washer
3. Remove the right side rear engine block coolant drain hole plug and washer.
Fig. 321: Engine Block Coolant Heater & Washer.
4. Remove the engine block coolant heater (114) and washer (115).
CRANKSHAFT BALANCER REMOVAL
Special Tools
EN 47699: Flywheel Holding Tool
J 41816: Crankshaft Balancer Remover
J 41816-2: Crankshaft End Protector
For equivalent regional tools, refer to Special Tools.
Removal
Fig. 322: Identifying Flywheel Holding Tool
NOTE: Do not use the crankshaft balancer bolt again. Install a NEW crankshaft balancer bolt during final assembly.
1. Install the EN 47699: tool (2), spacer (1), and bolt (3) to the block and flex plate.
Fig. 323: Identifying Flywheel Holding Tool
CAUTION: Refer to Fastener Caution .
2. Tighten the EN 47699: tool bolt (1) to 60 N.m (44 lb ft).
Fig. 324: View Of Crankshaft Balancer Bolt
3. Remove the crankshaft balancer bolt (139).
Do not discard the crankshaft balancer bolt. The balancer bolt will be used during the balancer installation procedure.
...