Complete digital service shop manual contains service, maintenance, and troubleshooting information for the Hyundai Entourage 2006-2009. Diagnostic and repair procedures are covered in great detail to repair, maintain, rebuild, refurbish or restore your vehicle like a professional mechanic in local service/repair workshop. This cost-effective quality manual is 100% complete and intact as should be without any missing pages. It is the same factory shop manual used by dealers that guaranteed to be fully functional to save your precious time.

This manual for Hyundai Entourage 2006-2009 is divided into different sections. Each section covers a specific component or system and, in addition to the standard service procedures, includes disassembling, inspecting, and assembling instructions. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. It is in the cross-platform PDF document format so that it works like a charm on all kinds of devices. You do not need to be skilled with a computer to use the manual.

EXCERPT:
2009 ENGINE Engine (G6DA - GSA 3.8L) - Entourage
COOLING SYSTEM
COMPONENT
Fig. 227: Identifying Cooling System Component And Tightening Torque (1 Of 2)
Fig. 228: Identifying Cooling System Component And Tightening Torque (2 Of 2)
ENGINE COOLANT REFILLING AND BLEEDING
WARNING: Never remove the radiator cap when the engine is hot. Serious scalding
could be caused by hot fluid under high pressure escaping from the
radiator.
CAUTION: When pouring engine coolant, be sure to shut the relay box lid and not to let coolant spill on the electrical parts or the paint. If any coolant spills,
rinse it off immediately.
1. Make sure the engine and radiator are cool to the touch.
2. Remove radiator cap.
3. Loosen the drain plug, and drain the coolant.
4. Tighten the radiator drain plug securely.
5. Remove, drain and reinstall the reservoir. Fill the tank halfway to the "F" mark with water, then up to the "F" mark with antifreeze.
6. Fill fluid mixture with coolant and water (4:6) slowly through the radiator cap. Push the upper/lower hoses of the radiator to ensure proper air bleeding.
7. Start the engine. When the cooling fan operates and coolant circulates, refill coolant through the radiator cap.
8. Repeat 7 until the cooling fan cycles 3~5 times and bleed air sufficiently out of the cooling system.
9. Install the radiator cap and fill the reservoir tank to the "MAX" line with coolant.
10. Run the vehicle under idle until the cooling fan operates 2~3 times.
11. Stop the engine and wait until the cooling system is cool to the touch.
12. Repeat 6 to 11 until the coolant level doesn't fall any more, bleed air out of the cooling system.
NOTE: Proper cooling system operation depends on the absence of trapped air within the system. It is essential that the cooling system be properly filled and bled before returning the vehicle to service.
CAP TESTING
1. Remove the radiator cap, wet its seal with engine coolant, then install it no pressure tester.
...

Hyundai Entourage 2006-2009 Workshop Repair & Service Manual