Complete digital official shop manual contains service, maintenance, and troubleshooting information for the 2002-2012 Daihatsu Copen [plus Service Manual for Type K3 Engine (K3-VE, K3-VE2)]. Diagnostic and repair procedures are covered in great detail to repair, maintain, rebuild, refurbish or restore your vehicle like a professional mechanic in local service/repair workshop. This cost-effective quality manual is 100% complete and intact as should be without any missing pages. It is the same factory shop manual used by dealers that guaranteed to be fully functional to save your precious time.

This manual for 2002-2012 Daihatsu Copen is divided into different sections. Each section covers a specific component or system and, in addition to the standard service procedures, includes disassembling, inspecting, and assembling instructions. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. It is in the cross-platform PDF document format so that it works like a charm on all kinds of devices. You do not need to be skilled with a computer to use the manual.

EXCERPT:
3-1-4 POINTS OF REMOVAL
(1) ENGINE MOUNTING REAR RIGHT BRACKET
1.Place a garage jack at a connecting point between the engine assembly and the transaxle assembly so as to sustain it.
CAUTION
Never apply a jack to the oil pan of the engine assembly or the transaxle assembly.
When applying a garage jack, interpose a wooden block or cloth so as not to cause any scratch.
Care must be exercised not to allow the engine to lower while the engine is sustained with the jack.
2.Disconnect the engine mounting rear insulator SIA from the engine mounting rear right bracket.
NOTE
It is advisable to carry out the work from the tire house at the left side of the vehicle, using a long extension bar.
3.Remove the engine mounting rear right bracket from the engine block. Temporarily secure it.
(2) Frame Ay
Slacken the retaining bolts of the frame assembly a little at a time so as to lower the front side about 15 mm; the rear side about 25mm.
CAUTION
Since there are possibilities that the frame assembly may drop, do not lower it more than 25 mm.
(3) POWER STEERING GEAR AY
Remove the retaining bolts that attach the power steering gear assembly to the frame assembly.
(4) ENGINE MOUNTING REAR RIGHT BRACKET
Pull out the engine mounting rear right bracket from the right side of the vehicle.
(5) ENGINE MOUNTING REAR INSULATOR SIA
Remove the engine mounting rear insulator SIA. Pull it out from the right side of the vehicle.
3-1-5 INSPECTION
(1) ENGINE MOUNTING REAR INSULATOR SIA
Replace any insulator that exhibits cracks, or a flattened condition.
3-1-6 POINTS OF INSTALLATION
(1) ENGINE MOUNTING REAR INSULATOR SIA
Install the engine mounting rear insulator SIA to the frame assembly.
...