Complete digital official shop manual contains service, maintenance, and troubleshooting information for the Chevrolet SSR 2003-2006. Diagnostic and repair procedures are covered in great detail to repair, maintain, rebuild, refurbish or restore your vehicle like a professional mechanic in local service/repair workshop. This cost-effective quality manual is 100% complete and intact as should be without any missing pages. It is the same factory shop manual used by dealers that guaranteed to be fully functional to save your precious time.

This manual for Chevrolet SSR 2003-2006 is divided into different sections. Each section covers a specific component or system and, in addition to the standard service procedures, includes disassembling, inspecting, and assembling instructions. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. It is in the cross-platform PDF document format so that it works like a charm on all kinds of devices. You do not need to be skilled with a computer to use the manual.

EXCERPT:
2005 ENGINE Engine Mechanical - 6.0L - SSR
Crankcase Ventilation Hoses/Pipes Replacement
Removal Procedure
Fig. 56: Identifying Positive Crankcase Ventilation (PCV) Foul Air Hose
1. Remove the positive crankcase ventilation (PCV) foul air hose from the intake manifold and valve rocker arm cover.
2. Remove the air cleaner resonator outlet duct. Refer to Air Cleaner Resonator Outlet Duct Replacement in Engine Controls - 6.0L.
Fig. 57: Vent Hose
3. Remove the PCV fresh air hose (2) from the valve rocker arm cover (1).
Installation Procedure
Fig. 58: Vent Hose
1. Install the PCV fresh air hose (2) to the valve rocker arm cover (1).
2. Install the air cleaner resonator outlet duct. Refer to Air Cleaner Resonator Outlet Duct Replacement in Engine Controls - 6.0L.
Fig. 59: Identifying Positive Crankcase Ventilation (PCV) Foul Air Hose
3. Install the PCV foul air hose to the intake manifold and valve rocker arm cover.
Intake Manifold Replacement
Removal Procedure
Fig. 60: Disconnecting Vacuum Brake Booster Hose (4.8L, 5.3L, 6.0L)
1. Remove the throttle body. Refer to Throttle Body Assembly Replacement in Engine Controls - 6.0L.
2. Remove the fuel injectors. Refer to Fuel Injector Replacement in Engine Controls - 6.0L.
3. Remove the vacuum brake booster hose.
Fig. 61: Removing/Installing Manifold Absolute Pressure (MAP) Sensor
4. Remove the manifold absolute pressure (MAP) sensor. Refer to Manifold Absolute Pressure (MAP) Sensor Replacement in Engine Controls - 6.0L.
Fig. 62: View Of EVAP Purge Solenoid Vent Tube
5. Remove the evaporative emission (EVAP) purge solenoid vent tubes (1) and (2).
Fig. 63: Removing/Installing Intake Manifold Bolts
6. Remove the intake manifold bolts (512).
7. Remove the intake manifold (500).
Fig. 64: View Of Intake Manifold Gasket
8. Remove the intake manifold gaskets (1) from the intake manifold.
9. Discard the old intake manifold gaskets.
Installation Procedure
Fig. 65: View Of Intake Manifold Gasket
1. Install new intake manifold gaskets (1) to the intake manifold.
Fig. 66: Removing/Installing Intake Manifold Bolts
2. Install the intake manifold (500).
3. Apply a 5 mm (0.2 in) band of threadlock GM P/N 12345382 (Canadian P/N 10953489), or equivalent to the threads of the intake manifold bolts (512).
...