Complete digital official shop manual contains service, maintenance, and troubleshooting information for the Chevrolet Venture 1997-2005. Diagnostic and repair procedures are covered in great detail to repair, maintain, rebuild, refurbish or restore your vehicle like a professional mechanic in local service/repair workshop. This cost-effective quality manual is 100% complete and intact as should be without any missing pages. It is the same factory shop manual used by dealers that guaranteed to be fully functional to save your precious time.

This manual for Chevrolet Venture 1997-2005 is divided into different sections. Each section covers a specific component or system and, in addition to the standard service procedures, includes disassembling, inspecting, and assembling instructions. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. It is in the cross-platform PDF document format so that it works like a charm on all kinds of devices. You do not need to be skilled with a computer to use the manual.

EXCERPT:
2005 ENGINE Engine Mechanical - 3.4L - Montana & Venture
Valve Lifter Replacement
Removal Procedure
1. Remove the valve rocker arm cover. Refer to Valve Rocker Arm Cover Replacement - Left or Valve Rocker Arm Cover Replacement - Right.
2. Remove the lower intake manifold. Refer to Intake Manifold Replacement - Lower.
3. Remove the valve rocker arms and pushrods. Refer to Valve Rocker Arm and Push Rod Replacement.
Fig. 149: View Of Lifter Guide
4. Remove the lifter guide bolts.
5. Remove the lifter guide.
IMPORTANT: Place the valve train parts in a rack in order to ensure that they are installed in the same location from which they were removed.
6. Remove the lifters.
Installation Procedure
1. Coat the valve lifters using prelube GM P/N 1052367 (Canadian P/N 992869) or the equivalent.
2. Install the valve lifters in their original locations.
3. Install the lifter guide.
NOTE: Refer to Fastener Notice in Cautions and Notices.
4. Apply threadlock GM P/N 12345382 (Canadian P/N 10953489) or the equivalent to the lifter guide bolts and install the bolts.
Tighten: Tighten the bolts to 10 N.m (89 lb in).
5. Install the valve rocker arms and pushrods. Refer to Valve Rocker Arm and Push Rod Replacement.
6. Install the lower intake manifold. Refer to Intake Manifold Replacement - Lower.
7. Install the valve rocker arm cover. Refer to Valve Rocker Arm Cover Replacement - Left or Valve Rocker Arm Cover Replacement - Right.
8. Inspect for leaks.
Crankshaft Balancer Replacement
Tools Required
J 24420-C Harmonic Balancer Puller. See Special Tools.
J 29113 Balancer and Crank Sprocket Puller. See Special Tools.
Removal Procedure
1. Remove the drive belt. Refer to Drive Belt Replacement.
2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
3. Remove the right front tire and wheel. Refer to Tire and Wheel Removal and Installation .
4. Remove the right engine splash shield. Refer to Splash Shield Replacement - Engine in Body Front End.
5. Install a utility stand beneath the frame right side rail in order to support the frame/powertrain.
6. Remove the two frame RIGHT side bolts.
7. Use the utility stand to lower the frame in order to provide access to the crankshaft balancer.
Fig. 151: Installing Crankshaft Washer & Bolt
8. Remove the crankshaft balancer retaining bolt and washer.
...