Complete digital official shop manual contains service, maintenance, and troubleshooting information for the GMC Safari 1985-2005. Diagnostic and repair procedures are covered in great detail to repair, maintain, rebuild, refurbish or restore your vehicle like a professional mechanic in local service/repair workshop. This cost-effective quality manual is 100% complete and intact as should be without any missing pages. It is the same factory shop manual used by dealers that guaranteed to be fully functional to save your precious time.

This manual for GMC Safari 1985-2005 is divided into different sections. Each section covers a specific component or system and, in addition to the standard service procedures, includes disassembling, inspecting, and assembling instructions. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. It is in the cross-platform PDF document format so that it works like a charm on all kinds of devices. You do not need to be skilled with a computer to use the manual.

EXCERPT:
2005 ENGINE Engine Mechanical - 4.3L - Astro & Safari
Cylinder Head Removal - Right
Fig. 245: Locating Spark Plugs
1. Remove the spark plugs.
Fig. 246: Removing Spark Plug Wire Support
2. Remove the rear bolt and the spark plug wire support.
Fig. 247: Locating Cylinder Head Bolts (Right)
3. Remove the cylinder head bolts and discard.
Fig. 248: Removing/Installing Cylinder Head (Right)
NOTE: After removal, place the cylinder head on two wood blocks to prevent damage to the sealing surfaces.
4. Remove the cylinder head.
Fig. 249: View Of Cylinder Head Gasket And Alignment Pins - Right
5. Remove and discard the cylinder head gasket.
Fig. 250: Removing Cylinder Head Locator Pins
6. Remove the cylinder head locator dowel pins, if required.
Valve Lifter Removal
Tools Required
J 3049-A Valve Lifter Remover. See Special Tools.
Fig. 251: View Of Valve Lifter Pushrod Guides
IMPORTANT: Place the components in a rack so that the components can be reinstalled
to their original location.
1. Remove the bolts and valve lifter pushrod guide.
Fig. 252: View Of Valve Lifters
IMPORTANT: Place the valve lifters in the rack in the upright position in order to
maintain the oil inside the valve lifters.
2. Remove the valve lifters.
Fig. 253: Using J 3049-A To Remove The Stuck Valve Lifters
IMPORTANT: Some valve lifters may be stuck in the valve lifter bores because of gum or varnish deposits and may require the use ofJ 3049-A for removal. See Special Tools.
3. Use the J 3049-A in order to remove the stuck valve lifters. See Special Tools.
Oil Filter Adapter Removal
...