Complete digital official shop manual contains service, maintenance, and troubleshooting information for the Cadillac Seville 1980-2004. Diagnostic and repair procedures are covered in great detail to repair, maintain, rebuild, refurbish or restore your vehicle like a professional mechanic in local service/repair workshop. This cost-effective quality manual is 100% complete and intact as should be without any missing pages. It is the same factory shop manual used by dealers that guaranteed to be fully functional to save your precious time.

This manual for Cadillac Seville 1980-2004 is divided into different sections. Each section covers a specific component or system and, in addition to the standard service procedures, includes disassembling, inspecting, and assembling instructions. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. It is in the cross-platform PDF document format so that it works like a charm on all kinds of devices. You do not need to be skilled with a computer to use the manual.

EXCERPT:
2004 ENGINE Engine Mechanical (Repair Instructions [3 of 4]) - Seville
Engine Mechanical (Repair Instructions [3 of 4]) - Seville
OFF-VEHICLE REPAIR INSTRUCTIONS - PART 2
CRANKSHAFT BALANCER CLEANING AND INSPECTION
Cleaning Procedure
1. Clean the crankshaft balancer in solvent that is compatible with the rubber.
2. Dry the crankshaft balancer with compressed air.
Inspection Procedure
CAUTION: Refer to Safety Glasses Caution in Cautions and Notices.
Fig. 1: Identifying Hub-to-crankshaft
1. Inspect the crankshaft balancer for the following:
Worn or damaged hub-to-crankshaft surface (1)
Worn, grooved, or damaged hub seal surface (2). A crankshaft balancer hub seal surface with excessive scoring, grooves, rust, or other damage must be replaced.
Bent, damaged or missing crankshaft front oil seal shield (3)
Worn, chunking, or deteriorated rubber between the hub and pulley (4)
Damaged drive belt ribs (5)
2. Repair or replace the crankshaft balancer as necessary.
ENGINE FLYWHEEL CLEANING AND INSPECTION
Cleaning Procedure
1. Clean the engine flywheel in solvent.
2. Dry the engine flywheel with compressed air.
Inspection Procedure
Fig. 2: View of Engine Flywheel
1. Inspect the engine flywheel for the following conditions:
Stress cracks around the engine flywheel-to-torque converter mounting bolt hole locations (1) and/or engine flywheel-to-crankshaft (2, 4)
CAUTION: Refer to Safety Glasses Caution in Cautions and Notices.
IMPORTANT: Do not attempt to repair the welded areas that retain the ring gear to the engine flywheel plate. Install a new engine flywheel.
Cracks at welded areas that retain the ring gear onto the engine flywheel (3)
Damaged or missing ring gear teeth (5)
2. Replace the engine flywheel as necessary.
PISTON AND CONNECTING ROD DISASSEMBLE
Tools Required
J 43654 Piston Pin Clip Remover and Installer
Fig. 3: Removing/Installing Piston Rings
1. Remove the piston rings using a piston ring expander. Place each ring in a clean shop towel for storage.
...