Complete digital official shop manual contains service, maintenance, and troubleshooting information for the Chevrolet Captiva 2006-2011. Diagnostic and repair procedures are covered in great detail to repair, maintain, rebuild, refurbish or restore your Chevrolet Captiva 2006-2011 like a professional mechanic in local service/repair workshop. This cost-effective quality manual is 100% complete and intact as should be without any missing pages. It is the same factory shop manual used by dealers that guaranteed to be fully functional to save your precious time.

This manual for Chevrolet Captiva 2006-2011 is divided into different sections. Each section covers a specific component or system and, in addition to the standard service procedures, includes disassembling, inspecting, and assembling instructions. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. It is in the cross-platform PDF document format so that it works like a charm on all kinds of devices. You do not need to be skilled with a computer to use the manual.

EXCERPT:
Power Sunroof Calibration
Condition
Some customers may comment that the sunroof may not close completely or after reaching closed position does not stop and continues to operate until the vent position is reached.
Re-Calibration Description
Sunroof Control Unit (SCU) has been designed to memorize closing and opening steps. However, the above condition may occur due to a loss of the memorized positioning data. The memorized positioning data can be lost when the operating current increases unusually over the specification operating current, 3.5-4.0 ampere because the foreign material is on sunroof guide rail or an object blocks the sunroof closing during operation.
SCU Re-Calibration Procedures
1. Press the switch rearward direction until the sunroof tilted open. Release the switch when the sunroof has fully opened.
Important: If the sunroof opens slightly and stops, release then press the switch and hold it and repeat these steps until the sunroof opens fully.
2. If the sunroof is stopped when close movement, press the switch forward direction until the sunroof close fully.
3. Press the switch rearward direction until the sunroof open for 15 seconds.
4. Confirm the re-calibration procedures by performing sunroof opening and closing operation.
...
Outer Belt Sealing Strip Replacement
Removal Procedure
1. Lower the window completely.
2. Remove the window outer sealing strip screws.
3. Remove the outside rearview mirror. Refer to Mirror Replacement .
4. Lift the window outer sealing strip off the door.
Installation Procedure
Notice: Refer to Fastener Notice in the Preface section.
1. Press the outside channel molding onto the door.
2. Install the window outer sealing strip screws.
Tighten
Tighten the window outer sealing strip screws to 1.3 N·m (12 lb in).
3. Install the outside rearview mirror. Refer to Mirror Replacement .
4. Raise the window.
...