Complete digital official shop manual contains service, maintenance, and troubleshooting information for the Chevrolet Celebrity 1982-1990. Diagnostic and repair procedures are covered in great detail to repair, maintain, rebuild, refurbish or restore your vehicle like a professional mechanic in local service/repair workshop. This cost-effective quality manual is 100% complete and intact as should be without any missing pages. It is the same factory shop manual used by dealers that guaranteed to be fully functional to save your precious time.

This manual for Chevrolet Celebrity 1982-1990 is divided into different sections. Each section covers a specific component or system and, in addition to the standard service procedures, includes disassembling, inspecting, and assembling instructions. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. It is in the cross-platform PDF document format so that it works like a charm on all kinds of devices. You do not need to be skilled with a computer to use the manual.

EXCERPT:
1990 Chevrolet Celebrity
2.5L 4-CYL - VINS [R & U] 1990 ENGINE General Motors 2.5L 4-Cylinder
REMOVAL & INSTALLATION
GENERAL PRECAUTION
NOTE: For reassembly reference, label all electrical connectors, vacuum hoses and fuel lines before removal. Also place mating marks on engine hood and other major assemblies before removal.
FUEL PRESSURE RELEASE
Loosen fuel tank filler cap to release tank pressure. Remove fuel pump fuse. Operate engine until it stalls. Crank engine for an additional 3 seconds to release residual line pressure. Reinstall fuel pump fuse with ignition off.
ENGINE
CAUTION: Relieve fuel pressure. Remove fuel pump fuse. Start and run engine until engine dies from lack of fuel. Engage starter for an additional 3 seconds.
Removal ("A" Body)
1. Disconnect battery cables. Remove hood. Drain cooling system and disconnect radiator hoses. Remove air cleaner. Disconnect engine wiring harness connector. Disconnect vacuum and heater hoses. Remove A/C compressor with hoses attached and place aside.
NOTE: On "A" Body, engine only is lifted from engine compartment.
2. Remove front reaction rod/strut. Disconnect throttle and transaxle linkage. Remove transaxle-to-engine bolts, except 2 upper bolts. Remove front mount-to-cradle nuts. Remove forward exhaust pipe. Remove converter housing cover or flywheel inspection cover. Remove converter-to-flexplate bolts, on A/T models. On all models, remove starter motor.
3. Remove power steering pump with hoses attached and position aside (if equipped). Remove rear transaxle support bracket bolts. Disconnect fuel line at fuel filter.
4. Position jack with wood block under transaxle and raise engine and transaxle until front engine mount studs clear cradle. Support engine weight with lift equipment. Remove upper transaxle-to-engine bolts.
Remove engine.
Installation
To install, reverse removal procedure. With engine off, fill radiator until level is even with filler neck. Run engine until upper radiator hose is hot. Add coolant as necessary. After 5 minutes, add coolant to base of filler neck and install cap. Allow engine to cool, then add coolant to recovery reservoir to ADD or FULL COLD mark. Install cap.
Removal ("N" Body)
...