Complete digital official shop manual contains service, maintenance, and troubleshooting information for the Chevrolet S10 1994-2004. Diagnostic and repair procedures are covered in great detail to repair, maintain, rebuild, refurbish or restore your Chevrolet S10 1994-2004 like a professional mechanic in local service/repair workshop. This cost-effective quality manual is 100% complete and intact as should be without any missing pages. It is the same factory shop manual used by dealers that guaranteed to be fully functional to save your precious time.

This manual for Chevrolet S10 1994-2004 is divided into different sections. Each section covers a specific component or system and, in addition to the standard service procedures, includes disassembling, inspecting, and assembling instructions. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. It is in the cross-platform PDF document format so that it works like a charm on all kinds of devices. You do not need to be skilled with a computer to use the manual.

EXCERPT:
2004 ENGINE Engine Mechanical - 4.3L - Blazer/S-10, Jimmy/Sonoma
Cylinder Head Removal - Left
Fig. 411: View Of Engine Coolant Temperature Sensor
1. Remove the engine coolant temperature sensor, if applicable.
Fig. 412: View Of Engine Coolant Temperature Gage Sensor
2. Remove the engine coolant temperature gage sensor, if applicable.
Fig. 413: View Of Spark Plugs (Left)
3. Remove the spark plugs.
Fig. 414: Locating Spark Plug Wire Support
4. Remove the bolts and the spark plug wire support.
Fig. 415: Locating Cylinder Head Bolts (Left)
5. Remove the cylinder head bolts and discard.
Fig. 416: Removing/Installing Cylinder Head (Left)
NOTE: After removal, place the cylinder head on two wood blocks to prevent damage to the sealing surfaces.
6. Remove the cylinder head.
Fig. 417: View Of Cylinder Head Gasket And Alignment Pins - Left
7. Remove and discard the cylinder head gasket.
Fig. 418: Locating Dowel Pins
8. Remove the cylinder head locator dowel pins, if required.
Cylinder Head Removal - Right
Fig. 419: Locating Spark Plugs
1. Remove the spark plugs.
Fig. 420: View Of Spark Plug Wire Support Bolt (Right)
2. Remove the rear bolt and the spark plug wire support.
Fig. 421: Locating Cylinder Head Bolts (Right)
3. Remove the cylinder head bolts and discard.
Fig. 422: Removing/Installing Cylinder Head (Right)
4. Remove the cylinder head.
NOTE: After removal, place the cylinder head on two wood blocks to prevent damage to the sealing surfaces.
Fig. 423: View Of Cylinder Head Gasket And Alignment Pins - Right
5. Remove and discard the cylinder head gasket.
...