Complete digital official shop manual contains service, maintenance, and troubleshooting information for the Toyota Echo 2000-2005. Diagnostic and repair procedures are covered in great detail to repair, maintain, rebuild, refurbish or restore your Echo like a professional mechanic in local service/repair workshop. This cost-effective quality manual is 100% complete and intact as should be without any missing pages. It is the same factory shop manual used by dealers that guaranteed to be fully functional to save your precious time.

This manual for Toyota Echo 2000-2005 is divided into different sections. Each section covers a specific component or system and, in addition to the standard service procedures, includes disassembling, inspecting, and assembling instructions. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. It is in the cross-platform PDF document format so that it works like a charm on all kinds of devices. You do not need to be skilled with a computer to use the manual.

EXCERPT:

2005 ENGINE Engine Mechanical - Echo

2005 ENGINE
Engine Mechanical - Echo
CO/HC
INSPECTION
NOTE: This check is used only to determine whether or not the idle CO/HC complies with regulations.
1. INSTALL CONDITIONS
a. Engine at normal operating temperature
b. Air cleaner installed
c. Air pipes and hoses of air induction system connected
d. All accessories switched OFF
e. All vacuum lines properly connected
f. SFl system wiring connectors fully plugged
g. Ignition timing check correctly
h. Transmission in neutral position
i. Tachometer and CO/HC meter calibrated by hand
2. START ENGINE
3. RACE ENGINE AT 2,500 RPM FOR APPROX. 180 SECONDS
4. INSERT CO/HC METER TESTING PROBE AT LEAST 40 cm (1.3 ft) INTO TAILPIPE
DURING IDLING
5. IMMEDIATELY CHECK CO/HC CONCENTRATION AT IDLE AND/OR 2,500 RPM
Complete the measuring with 3 minutes.
NOTE: When doing the 2 mode (idle and 2,500 RPM) test, these measurement order prescribed by the applicable local regulations.
Fig. 1: Inserting CO/HC Meter
If the CO/HC concentration does not comply with regulations, troubleshoot in the order given below.
Check heated oxygen sensor operation. (See DTC P0130, P2195, P2196: OXYGEN SENSOR CIRCUIT (BANK 1 SENSOR 1) STUCK LEAN/RICH )
See the table below for possible causes, and then inspect and correct the applicable causes if necessary.
Fig. 2: Identifying Heated Oxygen Sensor Operation Problem Chart
COMPRESSION
INSPECTION
1. WARM UP AND STOP ENGINE
Allow the engine to warm up to normal operating temperature.
2. REMOVE NO. 2 CYLINDER HEAD COVER
3. REMOVE IGNITION COIL (See REMOVAL )
4. REMOVE SPARK PLUGS
5. INSPECT CYLINDER COMPRESSION PRESSURE
a. Insert a compression gauge into the spark plug hole.
...