Complete digital official shop manual contains service, maintenance, and troubleshooting information for the Volkswagen Sharan 2010-2016. Diagnostic and repair procedures are covered in great detail to repair, maintain, rebuild, refurbish or restore your Sharan like a professional mechanic in local service/repair workshop. This cost-effective quality manual is 100% complete and intact as should be without any missing pages. It is the same factory shop manual used by dealers that guaranteed to be fully functional to save your precious time.

This manual for Volkswagen Sharan 2010-2016 is divided into different sections. Each section covers a specific component or system and, in addition to the standard service procedures, includes disassembling, inspecting, and assembling instructions. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. It is in the cross-platform PDF document format so that it works like a charm on all kinds of devices. You do not need to be skilled with a computer to use the manual.

EXCERPT:
6-speed dual clutch gearbox 02E - Edition 06.2015
Removing
– Raise vehicle. All 4 supports of lifting platform must be at same height.
– Move selector lever to position »P«.
– Remove engine cover panel ⇒ Rep. gr. 10 ; Engine cover panel; Removing and installing engine cover panel .
– Remove air filter housing ⇒ Rep. gr. 23 ; Air filter; Removing and installing air filter housing .
– Remove battery and battery tray ⇒ Electrical system; Rep. gr.27 ; Battery; Removing and installing battery .
– Remove selector lever cable from gearbox -arrows-.
Use pliers to remove the securing clip on the cable support bracket.
Do not use a sharp-edged lever, as the rubber grommet on the cable could be damaged.
– Remove cable with great care from cable support bracket on gearbox. Do not bend cable.
Cable can also be removed later on when gearbox is being lowered.
Then observe cable whilst lowering gearbox.
During later installation, do not clip »small« securing clips on until cable has been checked and adjusted ⇒ page 71 .
– Remove charge air pipe ⇒ Rep. gr. 21 ; Charge air system; Assembly overview - charge air system .
– Lay lint-free cloths on gear oil cooler and gearbox to catch escaping coolant.
Note
♦ On a warm engine, the cooling system is under high pressure.
♦ Before pulling off the coolant hoses, cover the cap on the coolant expansion tank with a cloth and open carefully.
– Clamp off coolant hoses using hose clamps to 25 mm - 3094- and disconnect hoses from gear oil cooler.
– Seal union of gear oil cooler using suitable bungs/plugs from engine bung set - VAS 6122- .
– Release rotary locking mechanism of connector for mechatronic unit -1- by turning in direction of starter and disconnect connector.
– Remove starter -A- ⇒ Electrical system; Rep. gr. 27 ; Starter; Removing and installing starter . It is advisable to remove the »lower« bolt first.
– Unscrew upper engine/gearbox connecting bolts using insert tool 18 mm - T10509- or insert tool 18 mm - T10179- . A bolt is located in the starter motor hole -arrow-. This bolt can be removed using socket - T10061- .
– If there are hose and cable connections in area of engine support eye for support bracket - 10-222A- , remove these now.
...