Complete digital official shop manual contains service, maintenance, and troubleshooting information for the Toyota Transmissions. Diagnostic and repair procedures are covered in great detail to repair, maintain, rebuild, refurbish or restore your transmissions like a professional mechanic in local service/repair workshop. This cost-effective quality manual is 100% complete and intact as should be without any missing pages. It is the same factory shop manual used by dealers that guaranteed to be fully functional to save your precious time.

This manual for Toyota Transmissions is divided into different sections. Each section covers a specific component or system and, in addition to the standard service procedures, includes disassembling, inspecting, and assembling instructions. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. It is in the cross-platform PDF document format so that it works like a charm on all kinds of devices. You do not need to be skilled with a computer to use the manual.

├── A440F, A440L.pdf
├── A442F
│   ├── RM314E.pdf
│   └── Supplement.pdf
├── G40, G45, G50, G52, G53, G54, G55, G56, G57, G58.pdf
├── H41, H42, H50, H55F.pdf
├── R151F.pdf
...

EXCERPT:

MANUAL TRANSMISSION - R 151 F Transmission

DISASSEMBLY OF TRANSMISSION (See pages MT-3.4)
1. REMOVE RElEASE FORK AND BEARING
2. REMOVE BACK-UP UGHT SWITCH. SHIFT LEVER RETAINER AND RESTRICT PINS
3. REMOVE CLUTCH HOUSING FROM TRANSMISSION CASE
4. REMOVE STRAIGHT SCREW PLUG, SPRING AND BALL
(a) Using a torx socket wrench, remove 1ho screw plug from the transfer adaptor.
(b) Using a magnetic finger, remove the spring and ball.
5. REMOVE TRANSFER ADAPTOR
(a) Remove the shift lever housing SCI bolt.
(b) Remove the shift lever shalt and housing.
NOTE Screw in a suitable bolt into the shalt and pull out the shaft.
(c) Remove the ten bolts.
(d) Using a plastic hammer, remove the transfer adaptor.
6. REMOVE FRONT BEARING RETAINER
(a) Remove the eight bolts.
(b) Using a plastic hammer, tap the front bearing retainer.
7. REMOVE BEARING SNAP RINGS
Using snap ring pliers, remove the two snap rings.
8. SEPARATE INTERMEDIATE PLATE FROM TRANSMISSION
CASE
(a) Using a brass bar and hammer, carefully tap off the transmission case.
(b) Remove the transmission case from the intermediate plate.
9. REMOVE MAGNET FROM INTERMEDIATE PLATE
10. MOUNT INTERMEDIATE PlATE IN VISE
(a) Use two clutch housing bolts, plate washers and suitable nuts as shown.
CAUTION: Install the plate washers in reverse of normal.
Increase or decrease plate washers so that the bolt tip and front tip surface of the nut are aligned.
(b) Mount the Intermediate plate in a vise.
11. REMOVE STRAIGHT SCREW PLUGS, lOCKING BALLS AND SPRINGS
(a) Using a torx socket wrench, remove the four plugs.
(b) Using a magnetic finger, remove t he four springs and balls.
12. REMOVE SET BOLTS
13. REMOVE SNAP RINGS
Using two screwdrivers and a hammer, remove the three snap rings.
...