Complete digital official shop manual contains service, maintenance, and troubleshooting information for the Harley Davidson FLH/FLT Twin CAM 88 & 103 1999-2005. Diagnostic and repair procedures are covered in great detail to repair, maintain, rebuild, refurbish or restore your motorbike like a professional mechanic in local service/repair workshop. This cost-effective quality manual is 100% complete and intact as should be without any missing pages. It is the same factory shop manual used by dealers that guaranteed to be fully functional to save your precious time.

This manual for Harley Davidson FLH/FLT Twin CAM 88 & 103 1999-2005 is divided into different sections. Each section covers a specific component or system and, in addition to the standard service procedures, includes disassembling, inspecting, and assembling instructions. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. It is in the cross-platform PDF document format so that it works like a charm on all kinds of devices. You do not need to be skilled with a computer to use the manual.

"'99-'05 FLH_FLT Twin CAM 88 & 103.pdf"
1999-2005 Harley Davidson FLH/FLT Twin CAM 88 & 103 Servie Manual; 712 pages

MODEL DESIGNATION
1999-2003
FLHT Electra Glide Standard
FLHTC/FLHTCI* Electra Glide Classic
FLHTCUI* Ultra Classic Electra Glide
FLHR/FLHRI* Road King
FLHRCI* Road King Classic
FLTR/FLTRI* Road Glide

EXCERPT:

Installation
l. Clean the axle in solvent and dry it thoroughly.
Make sure the bearing surfaces on the axle are free of burrs and nicks.
2. Apply an anti-seize lubricant to the axle shaft prior to installation.
3. On 1999 models, slide the rear brake caliper onto the locating post on the swing ann.
4. Position the rear wheel between the swing arms ides and place the drive belt on the sprocket.
5. Install the right side (Figure 18) and left side (Figure 19) spacers into the rear wheel seals or
bearings.
6. Remove the spacer block from between the brake pads.
CAUTION
When installing the rear wheel in the following steps carefully insert the brake disc between the brake pads in the caliper assembly. Do not force the brake disc as it can damage the leading edge of both brake pads.
7. On 2002 models, move the rear brake caliper (B, Figure 15) into position on the swing arm.
8. Lift the rear wheel and install the rear axle from the right side (A, Figure 15). Install the axle through the swing arm, the rear brake caliper mounting bracket and the other side of the swing
arm.
9. After the rear axle is instal led, make sure both axle spacers are still in place.
...

Harley Davidson FLH/FLT Twin CAM 88 & 103 1999-2005 Workshop Repair & Service Manual