Complete workshop repair service manual with electrical wiring diagrams for Lamborghini Gallardo, Murciélago, Diablo VT 1990-2013. It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.

Lamborghini Gallardo, Murciélago, Diablo VT service repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

"Workshop Manual Murcielago Coupé LP640-1 L824 2009.pdf"
1,173 pages

"Spare Parts Murcielago SV LP 670-4 2010.pdf"
1,1374 pages

"Workshop Manual Gallardo Coupé LP560-1 L714 2009.pdf"
1,659 pages

"Wiring Diagram & Parts Catalog Gallardo 2003-2008.pdf"
1,397 pages

"Workshop Manual Diablo VT 2WD 1994.pdf"
218 pages

EXCERPT:
1. Remove the mounting screws between clutch housing and crankcase.
2. Separate the gearbox from the engine and set the assembly on a stand with suitable clamping brackets.
3. Immediately install the shift lever device mounting bracket ∂on the propeller shaft pipe P/N 62495071 to lock the shift lever device and the shift lever into position and not to adjust the shift lever device itself;
4. Make the joint guard slide on the gearbox control rod and remove the cover shift control rod mounting pin from
the shift lever device one by means of a small punch; Unscrew the screw using a 13 mm wrench (e-gear).
5. Remove the cover mounting screws to the gearbox.
6. Remove the gearbox cover by pulling the shift control tooth from the gearbox rod teeth.
7. Remove the reverse gear gear-case side cap to reach one of the clutch housing nuts.
8. Position the gearbox with the clutch cover facing upwards.
9. Unscrew the clutch housing nuts and, by means of a rubber hammer, loosen the clutch housing from the gearbox and remove it.
...