Complete workshop service manual with electrical wiring diagrams for 1989-1990 Honda CB-1 (CB400F, NC27) Motorcycle. It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.
This service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.
'89-'90 CB-1 (aka CB400F, NC27).pdf
FRAME/BODY PANELS/EXHAUST SYSTEM
ELECTRIC STARTER/STARTER CLUTCH
LOWER JOINT REMOVAL/INSTALLATION
Install the shock absorber compressor and attachment on the rear shock absorber as shown.
SHOCK ABSORBER COMPRESSOR 070ME-0010000 (Not available in U.S.A.) or 07959-3290001 - screw assembly
Turn the compressor handle and slowly compress the spring.
Hold the lower joint and loosen the lock 'nut (turn the nut clockwise).
Remove the lower joint and clean off any locking agent from the threads.
Apply a locking agent to the damper threads.
Install the lower joint securely onto the damper rod.
Hole the lower joint and torque the lock nut.
TORQUE: 68 N•m (6.8 kg-m, 4~ft-lb)
Make sure the Lower joint Is aligned with the seat stopper pin and remove the compressor.
LOWER JOINTS NEEDLE BEARING
Remove the dust seals.