Complete workshop service manual with electrical wiring diagrams for Cummins ISM, ISMe, QSM (QSM11) Engines. It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.

This Cummins ISM, QSM Engines service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

FILELIST (1.1 GB):
br3653308 - Manual de Serviço Motores ISM, ISMe e QSM11.pdf
3666322 - ISM, ISMe & QSM11 Engines Troubleshooting & Repair Manual.pdf
3653524 - Manual de Serviço ISM11 CM876 SN.pdf
3653523 - Manual de Operação e Manutenção ISM11 CM876 SN.pdf
3653496 - Manual do Proprietário Motores ISMe.pdf
3666404 - Marine & Industrial QSM11 Engine Operation and Maintenance Manual.pdf
4017781 - Manual de Diagnóstico y Reparación Motores Series ISM11_QSM11.pdf
3653218 - ISM Diagrama Elétrico Cummins Brasil (Para ECM Part Nº 3680509, 3681404, 3681405, 3408501).pdf
3653525 - Manual do Proprietário ISM11 CM876 SN.pdf
3653476 - Diagrama Elétrico dos Motores ISM11 CM876 SN.pdf
4021942 - QSM11 Industrial Operation and Maintenance Manual.exe
3666322 - ISM, ISMe, and QSM11 Service Manual.exe
3666319 - ISM, ISMe Operation and Maintenance Manual.exe
3666266 - ISM & QSM11 Electronic Control System Troubleshooting & Repair Manual.exe

EXCERPT:
Use valve seat grinding machine, Part Number ST-685, and valve guide arbor set, Part Number 804, to grind the new valve seat inserts. Refer to Valve Seats - Grinding in the M11 Series Shop Manual, Bulletin 3666075.
Use valve guide driver (1), Part Number 3823947, to install the new valve guides.
Measure the valve guide installed height above the cylinder head top deck surface.
See Clean and Inspect for Reuse in this procedure for specifications.
Measure the valve guide inside diameter.
See Clean and Inspect for Reuse in this procedure for specifications.
If the valve guide is not within the specifications given, the valve guide must be replaced.
Use vegetable oil to lubricate the injector sleeve o-rings.
Install the o-ring (1) in the groove of the injector sleeve.
Use injector sleeve driver, Part Number ST-1227, to install the injector sleeve into the cylinder head. Remove the sleeve driver.
Install injector sleeve holding tool, Part Number ST-1179, in the injector sleeve.
Torque Value: 50 N•m [ 37 ft-lb ]
Install the injector sleeve driver.
Hit the driver with a mallet to seat the sleeve in the bore.
Remove the driver and tighten the injector sleeve holding tool capscrew again.
Torque Value: 50 N•m [ 37 ft-lb ]
Use injector sleeve expander, Part Number ST-880, to expand the upper section of the injector sleeve.
Adjust the expander roller edge (1) and collar (2) to the clearance specified.
Clearance 27 mm [ 1.06 in ]
...