Complete workshop service manual with electrical wiring diagrams for Honda NT650 1988-2005 Motorcycle. It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.

This Honda NT650 1988-2005 service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

"'88-'91 NT650 Hawk GT (EN).pdf"
269 pages

"'98 NT650V Deauville (NT650VW) Manual de Taller (ES).pdf"
444 pages

"'98-'05 NT650V (EN).pdf"
495 pages

EXCERPT:
Table of Contents
General Information
Frame/Body Panels
Exhaust System
Maintenance
Lubrication System
Fuel System
Cooling System
Engine Removal/Installation
Clutch/Gearshift Linkage
Alternator/Starter Clutch
Cylinder Head/Valves
Cylinder/Piston
Crankshaft!Transmission
Final Drive
Front Wheel/Suspension
Steering
Rear Wheel/Suspension
Hydraulic Brake
Battery/Charging System
Ignition System
Electric Starter
Lights/Meters/Switches
Wiring Diagram
Troubleshooting
...
CRANKPIN OIL CLEARANCE
NOTE:
• Do not rotate the crankshaft during inspection.
Clean off any oil from the connecting rod bearing inserts and crankpin.
Put a strip of plastigauge on each crankpin avoiding oil hole.
Install the connecting rod bearing and bearing cap to the original location.
Install and tighten the connecting rod bearing cap nuts in a crisscross pattern in several steps.
Torque: 33 N·m (3.4 kgf-m, 25 lbf-ft}
Remove the connecting rod bearing cap nuts, bearing cap and bearing.
Measure the compressed plastigauge at its widest point on each crankpin to determine the oil clearance.
Service Limit: 0.08 mm (0.003 in)
If the clearance exceeds the service limit, select the correct replacement bearings as follows.
CONNECTING ROD BEARING SELECTION
Determine the connecting rod I. D. number.
The code will be either a number 1 or 2 located on the rod in the area shown.
Determine the corresponding crankpin O.D. code (or measure the crankpin O.D.). the code will be either a letter A or B on the crank weight.
...