Complete workshop & service manual with electrical wiring diagrams for Honda NX250/NX650 1988-1990 Motorcycle. It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.

This Honda NX250/NX650 1988-1990 service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

"'88-'89 NX650.pdf"
252 pages

"'88-'90 NX250.pdf"
244 pages

EXCERPT:
CYLINDER HEAD COVER REMOVAL
Remove the following components:
-Fuel tank (page 4-3)
-Carburetor and carburetor insulator (page 4-7 and Bt
-Oil pipe bolts, sealing washers and oil pipe
-Cylinder head cover breather tube
-Spark plug cap
-Clutch cable clamp
-Engine hanger plates
-tapet hole caps
Remove the crankshaft hole cap and timing hole cap.
Turn the crankshaft and align the "T" mark on the flywheel with the index notch on the left crankcase cover when on the compression stroke (page 3-6).
Remove the cylinder head cover bolts.
NOTE:
Loosen the bolts indicated by the arrows. Remove these bolts after removing the cylinder head cover.
Slide the cylinder head cover to the intake side and remove it.
Remove the bolts from the cylinder head cover.
...