Complete workshop & service manual with electrical wiring diagrams for Honda Prelude 1978-2001. It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.

This Honda Prelude 1978-2001 service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

├── '83.pdf
├── '85\ 2DR\ Coupe\ Supplement.pdf
├── '87\ Supplement.pdf
├── '88.pdf
├── '89\ Supplement.pdf
├── '90\ Supplement.pdf
├── '92.pdf
├── '93.pdf
├── '93\ Supplement.pdf
├── '93.pdf
├── '94\ Supplement.pdf
├── '95\ Supplement.pdf
├── '96\ Supplement.pdf
└── '97-'99.pdf
└── …

EXCERPT:
Wheel Alignment
Caster
NOTE: For proper inspection/adjustment of the wheel alignment, check and adjust the following before checking the alignment.
• Check that the suspension is not modified.
• Check the tire size and tire pressure.
• Check the runout of the wheels and tires.
• Check the suspension ball joints. (Hold a wheel with your hands and move it up and down and right and left to check for wobbling.)
Inspection
NOTE: Use commercially-available computerized four wheel alignment equipment to measure wheel alignment
(caster, camber, toe, and/or turning angle).
Follow the equipment manufacturer's instructions.
1. Check the caster angle.
2. If out of specification, record the caster reading, then adjust the caster.
Adjustment
Without ATTS:
NOTE: Caster angle can be adjusted by increasing or decreasing the number of the adjusting shims. Remove and install the radius rod each time the caster angle is adjusted.
1. Raise the front of the vehicle, and support it with safety stands in the proper locations (see section 1).
2. Remove t he self- locking nut on t he end of the radius rod.
3. Remove the flange bolts at the radius rod on the lower arm, and remove the radius rod (see page 18-9).
4. Adjust the caster angle by increasing or decreasing the adjusting shims.
NOTE:
• Do not use more than two adjusting shims.
• One adjusting shim changes the caster angle by 40' and the caster angle can be adjusted by 1°20' maximum.
• One adjusting shim is 3.2 mm (0.13 in) in thickness SELF-LOCKING NUT 54 N·m (5.5 kgf·m, 40 lbf.ft)
Replace
ADJUSTING SHIM RADIUS ROD
5. After the adjustment, install the radius rod onto the lower arm, and tighten the flange bolts (see page 18-11)
6. Tighten the new self-locking nut to the specified torque.
…